Bedienungsanleitung Kalorik TKG SIS 1002 (Seite 13 von 64) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch)

713542

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don’t change the page numbering. Keep the

language integrity.

TKG SIS 1002 - 130424

Assembly page 13/64

Fax +32 2 359 95 50

STEAM-IRONING

• Fill the water tank with water and insert the mains plug into a wall socket.

• As indicated on the temperature dial and in the table, steam ironing is only possible at

higher ironing temperatures, so set the dial to  or .

• Press the boiler power switch. The switch will light up and the pump pilot light will flash until

the required temperature is reached. Then it becomes steady.

• Press the iron power switch and set the temperature dial of the iron to the desired position.

The iron power switch and the indicator lamp of the iron will light up. When the iron has

reached the desired temperature, its pilot light will go out. You can now use the steam

function.

• Turn the steam control knob to regulate the amount of steam. Note: the maximal steam

rate (“MAX”) can only be used when the ironing temperature is higher than position ,

or else water will drip from the sole.

• Press the steam button to release steam from the soleplate of the iron. Release the button

and the steam will stop. If you want a continuous jet of steam, press the steam button

down and slide its purple top part backwards so that the steam button locks. To stop the

continuous jet of steam, push the purple part of the button forward again and release the

steam button.

• When ironing, the pilot light of the iron will go on and off from time to time. This means that

the temperature of the iron is regulated by its thermostat. You can continue ironing.

• When you use a lot of steam in a very short time, the steam output is lightly reduced until

your appliance produces enough steam to reduce the difference. This phenomenon also

happens when there is not enough water in the water tank.

• When the water tank is running empty, the water refill indicator will come on. If you want

to go on using the steam function, you will have to refill the water tank. The water refill

indicator will go out when the water tank has been filled.

Note: when you start using the steam function, it is normal that the electrical pump makes

some vibrating sounds. This is due to the air inside the anti-calc cartridge and will lessen when

the air has been pumped out. If the noise has not diminished after 60 seconds, check if the

cartridge has been assembled correctly.

STEAMING IN A VERTICAL POSITION

Position the temperature dial on its maximum level for vertical steam ironing. The steam rate

can be adjusted according to your needs.

You have to hang the cloth you want to smooth out avoiding the creases and place the iron in

a vertical position at a few centimetres from the piece of cloth. Then move the iron and press

the burst of steam button at the same time.

DRY IRONING

• Plug in the appliance and press the iron power switch.

• Use the temperature dial to set the temperature needed.

• When the indicator lamp of the iron goes out for the second time, you can start ironing.

• For ironing without steam, leave the boiler power switch in OFF position and do not press

the steam button.

WHEN FINISHED IRONING

• We recommend cleaning the iron after use as follows: fill the water tank, plug in the

appliance, press the boiler power switch and the iron power switch, put the temperature

dial on position “LINEN” and the steam regulator on MAX and let the iron heat for 10

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kalorik TKG SIS 1002 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info