Bedienungsanleitung Karcher AD 2 Battery (Seite 15 von 172) (Alle Sprachen)

803786

Zoom out

Zoom in

Vorherige Seite

1/172

Nächste Seite

English 15

Operation

Integrated filter cleaning system

Note

The filter cleaning system is intended for intermediate

cleaning when vacuuming large amounts of ash.

The filter cleaning system allows the dirty flat fold filter

to be cleaned at the push of a button, which increases

the suction performance again.

Note

After pressing the filter cleaning button several times,

check the container for its filling volume. Otherwise dirt

can escape when the container is opened.

1. Insert the handle of the suction hose into the filter

cleaning system connection on the device.

2. Press and hold the filter cleaning button for 2 sec-

onds, while waiting 4 seconds between the individu-

al operations.

Illustration H

Interrupting operation

Note

If it is necessary to remove the suction head when work

is interrupted, the battery pack may become stuck. The

battery pack is locked in tightly and cannot fall out.

1. Position 0 Press to switch the device off.

Illustration G

2. Insert the handle of the suction hose into the filter

cleaning system connection on the device.

Illustration H

Ending operation

1. Position 0 Press to switch the device off.

Illustration G

2. Push the battery pack unlocking button forwards

and pull the battery pack upwards out of the battery

pack mounting.

Illustration I

3. Charge the battery pack if necessary, see chapter

Charging the battery pack.

Illustration C

Emptying the container

1. Remove the device head.

2. Remove the filter basket.

Illustration J

3. Empty the container.

Illustration K

Note

If necessary, clean the flat fold filter, see chapter Clean-

ing the flat fold filter.

Storing the device

1. Insert the handle of the suction hose into the filter

cleaning system connection on the device.

Illustration H

Wrap the suction hose around the device.

2. Store the device in a dry room.

Transport

몇CAUTION

Failure to observe the weight

Risk of injury and damage

Be aware of the weight of the device during transport

and storage.

1. When transporting in vehicles, secure the device

against slipping and tipping over according to the

applicable guidelines.

Manual transport

1. Lift and carry the device by the carrying handle.

Transport in vehicles

1. Secure the device against slipping and tipping over.

Care and service

Cleaning the flat fold filter

Note

The flat fold filter is located in the filter basket.

1. Remove the device head.

Illustration L

2. Remove the frame and filter.

Illustration M

3. Knock the dirt out of the filter and clean under run-

ning water if necessary. Do not rub or brush off.

Illustration N

4. Allow the filter to dry completely before installation.

Illustration O

5. Then reinsert the filter and then the frame.

6. Fit and lock the device head.

Illustration P

Troubleshooting guide

Malfunctions often have simple causes that you can

remedy yourself using the following overview. When in

doubt, or in the case of malfunctions not mentioned

here, please contact your authorised Customer Service.

Malfunctions

Device not running

Battery pack not correctly seated in the battery pack

mounting.

1. Push the battery pack into the battery pack mount-

ing until it latches into place.

Note

If necessary, remove the battery pack again and reinsert

it until it latches into place.

Charging state of the battery pack (see display) too low.

1. Charge the battery pack.

Defective battery pack or charger.

1. Replace the battery pack or charger.

The suction power decreases

Note

The amount that can be vacuumed can vary depending

on the vacuumed material.

Accessories (e.g. suction hose) are blocked.

1. Remove the blockage with a suitable aid.

The flat fold filter is dirty.

1. Clean the filter.

2. Knock the dirt out of the flat fold filter and clean it un-

der running water.

If necessary, replace the flat fold filter.

Technical data

Electrical connection

Battery voltage V 18

Nominal power W 200

Device performance data

Operating time with full battery charge

in normal operation (18 V, 2.5 Ah)

min 13

Operating time with full battery charge

in normal operation (18 V, 5 Ah)

min 25

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher AD 2 Battery Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info