Bedienungsanleitung Karcher Audio GEEN034 (Seite 18 von 20) (Deutsch, Englisch)

733562

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

18 | EN

Programming Track Order (via Remote Control)

You can store up to 20 tracks in a desired sequence. The programming can only be done in CD stop

mode (press the STOP ■ button if a CD is playing).

1. While in CD stop mode, press the PROGRAM button. “PROG” will be shown in the display

together with “P01” which is ashing.

2. Using the Skip/Search Down |◄◄ and Skip/Search Up ►►| buttons, select the track to be

played rst in the sequence.

In case of MP3-CD or USB playback where folders are included you need to rst select the

desired folder by pressing the FOLDER ▼/▲ buttons and then the Skip/Search Down |◄◄ and

Skip/Search Up ►►| buttons to select the track.

3. Press the PROGRAM button again. “P02” will be shown in the display.

4. Repeat the steps 2 - 3 to select up to 20 tracks for your sequence.

5. Press the PLAY/PAUSE button to start the playback of your sequence.

6. To delete your sequence, press the STOP ■ button twice.

Note:

• The programming mode will automatically quit in case there is no button pressed within about

one minute after pressing the PROGRAM button.

MP3 Playback from USB

1. Insert or take out a USB stick only while the unit is turned off.

2. After inserting a USB stick, turn the unit on and into CD/USB mode turning

the FUNCTION selector to “CD/USB”.

3. Select the USB mode by pressing the SOURCE button. “USB” appears in

the display.

4. The USB stick is now being read and the display will then show the total

no. of tracks.

5. Press the PLAY/PAUSE button to start playback.

6. Playback functions are the same as for CD playback as described above.

7. To stop playback, press the STOP ■ button.

Notes:

• A USB device must always be connected directly to the USB port of this product. The use of a

USB extension cord is not supported by this product. The USB port of this product cannot com-

municate with a computer directly.

• The reading time for a USB drive varies depending on the speed of the memory device and the

number of songs and folders.

• Always switch off the unit before removing a USB drive to prevent damage to your USB device.

The manufacturer is not responsible for the loss or damage of data.

• This unit does not support USB MP3 players due to their inherent lack of software compatibility.

Only USB “pen drives” (ash memory USB drives) can be used for MP3 playback.

• Only MP3 les can be played. Due to numerous methods of compression it may be that some

les or USB drives cannot be played.

Supported les: Bit rate 32kbps - 320kbps; sampling rate 32kHz, 44.1kHz and 48kHz decodable.

Phono

• Remove the stylus protector.

• Be sure that the tone arm is being detached from the tone arm rest before operating and re-

secured again afterwards.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher Audio GEEN034 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info