Bedienungsanleitung Karcher BD 43-25 C Bp (Seite 14 von 244) (Alle Sprachen)

804740

Zoom out

Zoom in

Vorherige Seite

1/244

Nächste Seite

- 4

DANGER

Risk of injury!

In dangerous situations, release the safety

switch/drive lever.

Open the lock of the fresh water reser-

voir.

Fill fresh water (maximum 60 °C) until

the lower edge of the filling nozzle.

Close the lock of the fresh water reser-

voir.

몇WARNING

Risk of damage. Only use the recommend-

ed detergents. With other detergents, the

operator bears the increased risk regarding

the operational safety and danger of acci-

dent.

Only use detergents that are free from sol-

vents, hydrochloric acid and hydrofluoric

acid.

Follow the safety instructions for using de-

tergents.

Note:

Do not use highly foaming detergents.

Recommended detergents:

Add the detergent to the fresh water

reservoir.

Note:

If the fresh water tank is empty, the clean-

ing head continues working without liquid

supply.

Adjust the water quantity using the reg-

ulating button according to the dirt on

the floor covering.

Note:

Carry out initial cleaning attempts with low

water volume. Increase water volume step-

by-step until the desired cleaning result is

achieved.

To improve the vacuuming result on tiled

floors the vacuum bar can be turned to an

oblique position of up to 5°.

Loosen the wing nuts.

Turn the vacuum bar.

Tighten the wing screws.

If the vacuum result is unsatisfactory the in-

clination of the straight vacuum bar can be

modified.

Adjust the rotary handle to incline the

suction bar.

The bend of the suction lips upon contact

with the floor is influenced with the height

adjustment.

Try adjusting the twist handles of the

height adjustment until the best vacu-

uming result is achieved.

ATTENTION

Risk of damage to the floor covering. Do

not operate the appliance on the spot.

Turn the program selection switch to

the desired cleaning program.

Pull the lever out and press it down; the

vacuum bar is lowered.

Note:

– For cleaning tiled floors, adjust the

straight suction bar in such a way that

cleaning is not done at an angle of 90

degrees to the joints.

– The inclined position and the inclination

of the suction bar can be adjusted to

achieve better suction results (see "Ad-

justing the suction bar").

– If the waste water tank is full, the float

closes the suction opening and the suc-

tion turbine runs at an increased speed.

If this is the case, shut the vacuum off

and drive to empty the waste water

tank.

Release the safety switch.

Set the program selection switch to suc-

tion or vacuuming.

Briefly drive forward and suck of the re-

maining water.

Raise the vacuum bar.

Charge battery, if required.

몇WARNING

Please observe the local provisions regard-

ing the wastewater treatment.

Take the water discharge hose from the

support and lower above a suited col-

lection device.

Crush or bend the dosing equipment.

Open the lid of the dosing equipment.

Drain off the dirt water - regulate the

water quantity by pressing or bending.

Rinse the waste water tank with clear

water.

Unscrew the lock of the fresh water res-

ervoir.

DANGER

Risk of injury! When loading or unloading

the machine, it may only be operated on

gradients up to the maximum value (see

"Technical Specifications"). Drive slowly.

몇CAUTION

Risk of personal injury or damage! Mind the

weight of the appliance during transport.

Use the pushing handle to push the ap-

pliance.

Operation

Filling in detergents

Fresh water

Detergent

Application Detergent

Routine cleaning of all water

resistant floors

RM 746

RM 780

Routine cleaning of glossy

surfaces (e.g. granite)

RM 755 es

Routine cleaning and basic

cleaning of industrial floors

RM 69 ASF

Routine cleaning and basic

cleaning of fine stoneware

tiles

RM 753

Routine cleaning of tiles in

sanitary areas

RM 751

Cleaning and disinfection in

sanitary areas

RM 732

Removal of coating from all

alkali-resistant floors (e.g.

PVC)

RM 752

Removal of coating from li-

noleum floors

RM 754

Setting the water quantity

Setting the Vacuum Bar

Oblique position

Inclination

Height

Cleaning

Lower the vacuum bar

Shutting Down the Appliance

Drain off dirt water

Drain off clean water

Transport

14 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher BD 43-25 C Bp Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info