Bedienungsanleitung Karcher BD 43-35 C Ep (Seite 13 von 192) (Alle Sprachen)

804739

Zoom out

Zoom in

Vorherige Seite

1/192

Nächste Seite

- 5

Remove the vacuum bar.

Unscrew the star grips.

Remove the plastic parts.

Remove the vacuum lips.

Insert new or reversed vacuum lips.

Insert the plastic parts.

Screw in and tighten the star grips.

Push down the device holding the push

handle so that the cleaning head is

raised.

Press the pedal for changing the brush-

es downward beyond its resistance.

Pull the device towards the back so that

the disc brush becomes accessible.

Place a new disc brush on the floor in

front of the device.

Drive the device with the raised clean-

ing head over the new disc brush and

lower the cleaning head.

The brush locks into the drive.

Drain off dirt water.

Lift up the waste water tank and put it

aside.

To ensure a reliable operation of the appli-

ance maintenance contracts can be con-

cluded with the competent Kärcher sales

office.

In case of danger of frost:

Empty the fresh and waste water tank.

Store the appliance in a frost-protected

room.

DANGER

Risk of injury! Set the programme selector

switch to "OFF" and disconnect the mains

plug prior to performing any work on the de-

vice.

Drain and dispose of the dirt water and

the residual fresh water.

Replacing the disk brushes Removing the waste water tank

Maintenance contract

Frost protection

Faults

Failure Correction

Appliance cannot be

started

Turn the program selection switch to the desired programme.

Operate the safety switch.

Insert the mains plug into the socket.

Is the indicator light voltage supply on?

Insufficient water quan-

tity

Check fresh water level, refill tank if necessary.

Increase the water volume on the regulating knob for water volume.

Clean sieve.

Insufficient vacuum per-

formance

Clean the seals between waste water tank and cover and check for tightness, replace if required.

Check the seals between waste water tank and fresh water tank for damage, replace if necessary.

Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir

Clean the fluff filter.

Clean the vacuum lips on the vacuum bar, replace if required

Check if the cover on the dirt water discharge hose is closed

Check the setting of the vacuum bar.

Check suction hose for blockages; clean if required.

Check the suction hose for tightness; replace if required.

Insufficient cleaning re-

sult

Check the brushes for wear, replace if required.

Suction turbine is run-

ning rough

Clean the swimmer.

Brush does not turn Check if foreign objects block the brush; remove foreign object if required.

Release the safety switch.

Wait for a while.

Operate the safety switch.

Vibrations during clean-

ing

You might need to use a softer brush.

In case of faults that cannot be remedied using the table below please contact the customer service.

13EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher BD 43-35 C Ep Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info