Bedienungsanleitung Karcher BP 5 (Seite 17 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

657242

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

– 5

Troubleshooting

몇 Caution

To avoid risks, all repairs and replacement of spare parts may only be carried out by the authorised customer service

personnel.

Prior to all work on the appliance, switch off the appliance and pull the power plug.

Fault Cause Remedy

Pump runs but does not

transport

Air in the pump see Chapter "Preparation" Fig. A to D and Chapter

"Operation"

Suction pipe blocked Switch off the pump, pull the mains plug and clean the

intake area.

Pre-filter is dirty Switch off the pump, pull the mains plug, allow the

pump to cool down, clean intake area, prevent dry run-

ning.

Remove the pre-filter and the check valve and clean it

under running water, flush dirt residues from the bot-

tom of the filler neck through the filler hole if necessary.

Restart by switching the pump back on.

Suction hose or connection

adapter not screwed in correct-

ly or completely.

Check whether all seals have been installed and are

seated correctly prior to assembly.

Manually tighten the suction hose and the connection

adapter.

Pump does not run or sud-

denly comes to a standstill

during operations

Power supply interrupted Check fuses and electrical connections

Pre-filter is dirty Remove the pre-filter and the check valve and clean it

under running water, flush dirt residues from the bot-

tom of the filler neck through the filler hole if necessary.

The appliance is in the auto-

matic mode.

Pressure in the system >

1.3 bar.

The pump automatically switches back on as soon as

the pressure in the system falls below 1.3 bar.

In automatic mode the device does not start up even

after switching it off and back on if there is an internal

pressure of more than 1.3 bar, thus, when a water col-

umn of more than 13 metres affects the pump.

Pump stops, LED "Error on

suction side" is illuminated.

Failure on the suction side,

pressure cannot build up

Switch off the pump and pull the power plug.

Remove the pre-filter and the check valve and clean it

under running water, flush dirt residues from the bot-

tom of the filler neck through the filler hole if necessary.

Restart by switching the pump back on.

Check connections on the suction side for leakage.

Restart by switching the pump back on.

Check if there is sufficient water in the suction contain-

er (e.g. cistern).

Flow rate very low -> the dry

run protection has switched off

the pump.

Check if there is sufficient water in the suction contain-

er (e.g. cistern).

The flow is insufficient. Open tap more.

Fault delivery side (leakage or

closed tap) during suction.

Pump does not end the suction

mode.

Open tap.

Check system for leakage. If the leakage cannot be

eliminated, install pressure equalization container.

(see special accessories)

17EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher BP 5 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info