Bedienungsanleitung Karcher DS 6 (Seite 14 von 178) (Alle Sprachen)

724848

Zoom out

Zoom in

Vorherige Seite

1/178

Nächste Seite

– 8

Caution! When the water tank is filled, the appliance

may only be operated in the horizontal position. Pri-

or to moving the appliance into the upright position,

the water tank must be drained. Otherwise the floor

can be damaged.

Note

Should the mains fuse trip upon switching on the appli-

ance, it could be due to the fact that other electronic de-

vices are simultaneously connected and operated on

the same electric circuit. Refer to chapter "Technical da-

ta" for mains fuse.

The appliance will shut down automatically if there is

risk of overheating. Turn the appliance off and pull the

power plug. Replace the HEPA filter. After the elimina-

tion of the disturbance, allow the appliance to cool down

for a at least 1 hour; then the appliance is ready for op-

eration again.

Illustration

 Connect suction hose to the appliance.

 Connect the handle to the telescopic vacuum pipe

and attach the floor nozzle.

Illustration

 Activate the release and extend or retract the inte-

rior pipe to the desired length.

Note: Adjust the telescoping pipe matching your

height so that you will be able to work comfortably

while walking upright.

Caution

Do not use the device if the water filter container is emp-

ty!

When the appliance is delivered, the intermediate filter

and the baffle plate are already installed. When filling,

make sure that these components are installed properly

(see: SCOPE OF DELIVERY). This could be the cause

of poor vacuuming performance or untimely failure of

the intermediate filter (see: FINISH OPERATION).

Illustration

 Open the appliance flap and remove the defoamer

liquid (FoamStop) as well as the water filter con-

tainer.

Illustration

 Remove the lid from the water filter container and

take out the baffle plate, then fill the water filter con-

tainer with tap water until the level settles between

the MIN and MAX markings (approx. 2.0 l)!

Illustration

 Add one cap full of the defoaming liquid (Foam-

Stop) to the water filter reservoir.

Note: The functioning of the vacuum cleaner is

based on the whirling of the suction air in the water

filter. In the process, sucked-in materials and de-

posits of cleaning agents from floors get collected

in the water bath. This can sometimes lead to the

formation of foam. It is necessary to add a capful of

the defoamer liquid to the water bath to avoid this

situation. Slight foam formation is normal and does

not hamper the functioning of the machine.

Illustration

 Note: Please refill water as soon as the water level

in the reservoir sinks below the MIN mark.

Insert the baffle plate and reattach the lid of the wa-

ter filter container. Install the complete water filter

container in the appliance.

Illustration

 Pull the power cable out of the appliance complete-

ly.

Illustration

 Insert the appliance plug into the mains socket.

 To switch on the appliance press the on/off switch.

Caution

Do not vacuum up large amounts of powdery materials

such as cocoa, flour, laundry detergent, pudding pow-

der or similar materials!

Illustration

 Use your foot to press the reversing switch of the

floor nozzle. The brush strips at the bottom of the

floor nozzle are extended.

Illustration

 Use your foot to press the reversing switch of the

floor nozzle. The brush strips at the bottom of the

floor nozzle are retracted.

Note

Due to the high suction power of the appliance, the suc-

tion nozzles can draw themselves too firmly to carpets,

upholstery, etc. during work. In this case, use the false

air slide to reduce the suction power. Close it again after

use.

Note: The crevice and upholstery nozzles are stored in

the appliance.

Illustration

 Open the accessories flap and take out the desired

nozzle for working.

for edges, joints, heaters and hard to reach locations.

for cleaning upholstered furniture, laced curtains, mat-

tresses, etc.

* depending on model

Illustration

 Turbo floor nozzle

(order no. 4.130-177.0)

brush and vacuum in one work cycle.

Especially suitable in order to pick up animal hair

and to vacuum high floor carpets. The drive of the

brush roller happens by the air stream.

There is not electrical outlet necessary.

Commissioning/ Operations

Connect accessories

Fill the water filter reservoir

Start working

Working with the floor nozzle

Vacuuming hard surfaces

Vacuuming carpeted floors

Working with the crevice nozzle and the

upholstery nozzle

Crevice nozzle

Upholstery nozzle

Turbo floor nozzle

14 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher DS 6 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info