Bedienungsanleitung Karcher HD 10-16-4 Cage (Seite 22 von 320) (Alle Sprachen)

725305

Zoom out

Zoom in

Vorherige Seite

1/320

Nächste Seite

– 8

You can rectify minor faults yourself with

the help of the following overview.

If in doubt, please consult the authorized

customer service.

DANGER

Risk of injury!

Always switch off the appliance and pull out

the mains plug before care and mainte-

nance work.

몇WARNING

Repair work and work on electrical compo-

nents may only be performed by the author-

ized customer service in non-explosion

danger areas.

– No power

Check the plugs and sockets.

Check whether the voltage indicated on

the type plate corresponds to the volt-

age of the socket.

Check the mains connection cable for

damages.

– Engine is overheated

Switch off appliance and let it cool

down. Remove the cause of the prob-

lem. Turn on the appliance again.

– Wrong nozzle

Check nozzle for correct size (see tech-

nical specifications).

– Air within the system

Vent pump:

Unscrew the nozzle. Switch on the ap-

pliance and let it run until the water ex-

iting from the spray pipe is bubble-free.

Switch off the appliance and fit the noz-

zle again.

– Nozzle is blocked/ washed out

Clean/ replace nozzle.

– Filter at the water connection is dirty

Clean filter at the water connection.

– Amount of water supply is too low.

Check water supply level (refer to tech-

nical data).

– Pipe inlets to pump are leaky or blocked

Check all supply lines to the high-pres-

sure pump for leaks or blockages.

3 drops per minute are permitted and

can come out from the lower side of the

appliance. Call Customer Service if

there is heavy leakage.

– Pipe inlets to pump are leaky or blocked

Check all supply lines to the high-pres-

sure pump for leaks or blockages.

– Air within the system

Vent pump:

Unscrew the nozzle. Switch on the ap-

pliance and let it run until the water ex-

iting from the spray pipe is bubble-free.

Switch off the appliance and fit the noz-

zle again.

– Amount of water supply is too low.

Check water supply level (refer to tech-

nical data).

– Incorrect nozzle inserted.

Replace the high-pressure nozzle with

the low-pressure nozzle.

– Filter at the detergent suction hose dirty

Clean filter.

– Backflow valve stuck

Remove the detergent hose and loosen

the backflow valve using a blunt object.

– Detergent container is empty

Fill/replace detergent container.

– The warranty terms published by our

competent sales company are applica-

ble in each country. We will repair po-

tential failures of the appliance within

the warranty period free of charge, pro-

vided that such failure is caused by

faulty material or defects in fabrication.

– The warranty comes only into effect if

your vender fills out the supplied reply

card completely at purchase, stamps

Troubleshooting

Appliance is not running

Device is not building up pressure

High pressure side is leaky

High pressure pump is vibrating

Water jet is not uniform

Device is not sucking in detergent

Warranty

22 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HD 10-16-4 Cage Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info