Bedienungsanleitung Karcher HD 10-25-4 SX (Seite 22 von 296) (Alle Sprachen)

725182

Zoom out

Zoom in

Vorherige Seite

1/296

Nächste Seite

– 7

You can sign with your dealer a contract for

regular safety inspection or even sign a

maintenance contract. Please take advice

on this matter.

Check connection cable for damages

(risk of electrical shock); get the dam-

aged connection cable replaced imme-

diately by an authorised customer ser-

vice person/ electrician.

Check the high pressure hose for dam-

ages (risk of bursting).

Please arrange for the immediate ex-

change of a damaged high-pressure hose.

Check appliance (pump) for leaks.

3 drops per minute are permitted and

can come out from the lower side of the

appliance. Call Customer Service if

there is heavy leakage.

Check oil level Please contact Custom-

er Service immediately if the oil is milky

(water in oil).

Clean the fine filter.

Unpressurize the appliance.

Unscrew the fastening screws of the

device hood; remove the device hood.

Unscrew lid with filter.

Clean the filter with clean water or com-

pressed air.

Reinstall in reverse sequence.

Clean filter at the detergent suck hose.

Have the maintenance of the device

performed by the customer service.

Oil change.

Note:

See "Specifications" for oil volume and

type.

Unscrew the fastening screws of the

device hood; remove the device hood.

Turn out the oil drain screw at the front

on the motor casing.

Drain the oil in a collection basin.

Screw in the oil drain screw.

Fill in new oil slowly; air bubbles should

go out.

Attach the lid of the oil container.

Fasten the device hood.

Empty and clean the detergent tank.

Pull out the locking cap for the deter-

gent tank along with the suction hose.

Lay the device on the reverse.

Empty and clean the detergent tank.

DANGER

Risk of injury by inadvertent startup of ap-

pliance and electrical shock.

–Prior to all work on the appliance,

switch off the appliance and pull the

power plug.

–Get the electrical components checked

and repaired only by authorised cus-

tomer service persons.

–Contact an authorised customer service

person in case of problems not men-

tioned in this chapter or if you are in

doubt or when you have been explicitly

asked to do so.

The indicator lamps display the operating

states (green) and interruptions (red).

Reset:

Set the appliance switch to "0".

Wait for a while.

Set the appliance switch to "I".

– Continuous green:

The appliance is now ready for opera-

tion.

– blinks green once:

Operational readiness has expired after

30 minutes.

The appliance has switched off after 30

minutes of continuous operation (safety

if the high pressure hose bursts).

Safety inspection/ maintenance

contract

Before each use

Weekly

Every 500 operating hours, at least

annually

Oil change

If required

Troubleshooting

Indicator lamp

Operating status display

22 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HD 10-25-4 SX Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info