Bedienungsanleitung Karcher HD10-23-4S (Seite 20 von 240) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

459053

Zoom out

Zoom in

Vorherige Seite

1/240

Nächste Seite

– 6

 Check connection cable for damages

(risk of electrical shock); get the dam-

aged connection cable replaced imme-

diately by an authorised customer

service person/ electrician.

 Check the high pressure hose for damages

(risk of bursting).

Please arrange for the immediate ex-

change of a damaged high-pressure hose.

 Check appliance (pump) for leaks.

3 drops per minute are permitted and

can come out from the lower side of the

appliance. Call Customer Service if

there is heavy leakage.

 Check oil level Please contact Custom-

er Service immediately if the oil is milky

(water in oil).

 Clean the fine filter.

Unpressurize the appliance.

Unscrew the fastening screws of the

device hood; remove the device hood.

Unscrew lid with filter.

Clean the filter with clean water or com-

pressed air.

Reinstall in reverse sequence.

 Clean filter at the detergent suck hose.

 Oil change.

Note

See "Technical Details" for details of oil

quantity and type.

 Unscrew the fastening screws of the

device hood; remove the device hood.

 Turn out the oil drain screw at the front

on the motor casing.

 Drain the oil in a collection basin.

 Turn out the oil drain screw.

 Fill in new oil slowly; air bubbles should

go out.

 Attach the lid of the oil container.

 Fasten the device hood.

 Empty and clean the detergent tank.

Pull out the locking cap for the deter-

gent tank along with the suction hose.

Lay the device on the reverse.

Empty and clean the detergent tank.

ƽ Danger

Risk of injury by inadvertent startup of ap-

pliance and electrical shock.

First pull out the plug from the mains before

carrying out any tasks on the machine.

Get the electrical components checked and

repaired only by authorised customer serv-

ice persons.

Contact an authorised customer service

person in case of problems not mentioned

in this chapter or if you are in doubt or when

you have been explicitly asked to do so.

 Check connection cable for damages.

 Call Customer Service in case of elec-

trical defects.

 Install the high pressure nozzle.

 Clean/ replace nozzle.

 Clean the fine filter; replace it, if neces-

sary.

 Deaerate the appliance (see "Start-up")

 Check water supply level (refer to tech-

nical data).

 Check all inlet pipes to the pump.

 Contact Customer Service if needed.

3 drops per minute are permitted and can

come out from the lower side of the appli-

ance. Call Customer Service if there is

heavy leakage.

 With stronger leak, have device

checked by customer service.

Before each use

Weekly

monthly or after 500 operating

hours

Oil change

If required

Troubleshooting

Appliance is not running

Pressure does not build up in the

appliance

Pump leaky

20 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HD10-23-4S Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info