Bedienungsanleitung Karcher HDS 10-20-4 M-MX (Seite 25 von 372) (Alle Sprachen)

726174

Zoom out

Zoom in

Vorherige Seite

1/372

Nächste Seite

– 6

 Switch on the pump with the power switch and al-

low to run for about 5-10 seconds.

 Close the hand spray gun.

 Set the appliance switch to "0/OFF“.

 Pull main plug out of socket with dry hands only.

 Remove water connection.

 Activate hand spray gun until device is pressure

less.

 Secure the trigger gun. To do so, push the safety

catch towards the front.

 Lock in the steel pipe into the holder of the appli-

ance hood.

 Roll up high pressure hose and electrical conduit

and hang them into the respective holders.

Device with hose drum:

 Before rolling up, stretch out the high pressure

hose.

 Turn the hand crank clockwise (Direction of the ar-

row).

Note: Do not twist high pressure hose and electrical

conduit.

ATTENTION

Risk of damage! Frost will destroy the appliance if the

water has not been completely drained.

 Store in a frost free area.

If the device is connected to a chimney, the following

must be observed:

ATTENTION

Threat of damage by penetrating cold air through the

chimney.

 Disconnect device from chimney when outside

temperature drops below 0 °C.

If it is not possible to store frost free, shut down device.

For longer work breaks or if a frost free storage is not

possible:

 Empty detergent tank.

 Drain water.

 Flush device with anti-freeze agent.

 Screw off water supply hose and high pressure

hose.

 Screw off supply hose at boiler bottom and drain

heating spiral empty.

 Operate device for max. 1 minute until the pump

and conduits are empty.

Note: Observe handling instructions of the anti-freeze

agent manufacturer.

 Fill anti-freeze agent of the trade into swimmer con-

tainer.

 Switch on appliance (without heater) till the appli-

ance has been completely rinsed.

A certain corrosion protection is achieved with this as

well.

몇 CAUTION

Risk of personal injury or damage! Consider the weight

of the appliance when storing it.

Figure 11

ATTENTION

Risk of damage! When loading the appliance with a

forklift, observe the illustration.

ATTENTION

Protect the trigger from damage during transport.

몇 CAUTION

Risk of personal injury or damage! Mind the weight of

the appliance during transport.

 When transporting in vehicles, secure the appli-

ance according to the guidelines from slipping and

tipping over.

 DANGER

Risk of injury by inadvertent start-up of appliance and

electric shock. Prior to all work on the appliance, switch

off the appliance and pull the power plug.

 Shut off water supply.

 Open the hand spray gun.



Switch on the pump with the power switch and al-

low to run for about 5-10 seconds.

 Close the hand spray gun.

 Set the appliance switch to "0/OFF“.

 Pull main plug out of socket with dry hands only.

 Remove water connection.

 Activate hand spray gun until device is pressure

less.

 Secure the trigger gun. To do so, push the safety

catch towards the front.

 Allow device to cool down.

Your Kärcher vender will inform you about the per-

formance of a periodic safety inspection resp. sign-

ing of a maintenance contract.

 Clean the sieve in the water connection.

 Clean the fine filter.

 Check oil level.

ATTENTION

Risk of damage! In case of lacteous oil inform Kärcher

customer service immediately.

 Clean sieve in the water shortage safe guard.

 Clean filter at the detergent suck hose.

 Oil change.

 Have the maintenance of the device performed by

the customer service.

 Perform the pressure test as per manufacturer's in-

structions.

 Take out sieve.

 Clean sieve in water and reinstall.

 Unpressurize the appliance.

 Unscrew the fine filter from the pump head.

 Remove the fine filter and the filter insert.

Storing the Appliance

Frost protection

Shutdown

Dump water

Flush device with anti-freeze agent

Storage

Transport

Care and maintenance

Maintenance intervals

Weekly

Monthly

Every 500 operating hours, at least annually

At least every 5 years, recurring

Maintenance Works

Clean the sieve in the water connection

Cleaning the fine filter

25EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HDS 10-20-4 M-MX Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info