Bedienungsanleitung Karcher HDS 1000 BE (Seite 29 von 428) (Alle Sprachen)

726230

Zoom out

Zoom in

Vorherige Seite

1/428

Nächste Seite

– 10

– RM 100 (Order No. 6.287-008) dis-

solves chalk and simple compounds of

chalk and detergents residues.

– RM 101 (Order No. 6.287-013) dis-

solves the deposits that cannot be dis-

solved using RM 100.

 Fill a 20 litre container with 15 l water.

 Add one litre of boiler decrusting agent.

 Connect the water hose directly to the

pump and hang in the other free end

into the container.

 Insert the connected spray pipe without

nozzle into the container.

 Start the engine according to the oper-

ating instructions of the engine manu-

facturer.

 Open the hand-spray gun and do not

close it during the decalcification pro-

cess.

 Set the appliance switch to a working

temperature of 40 °C.

 Let the appliance run till the working

temperature is reached.

 Switch off the appliance and let it stand

for 20 minutes. The hand-spray gun

must remain opened.

 Then pump out the machine until empty.

Note: As an anti-corrosion measure and for

neutralising the acid residue, we recom-

mend that you finally pump an alkaline so-

lution through the machine (for e.g. RM 81)

via the detergent tank.

ATTENTION

Risk of damage! Freezing water in the ap-

pliance can destroy parts of the appliance.

– Store the appliance in a heated room

during winter or empty it. During longer

breaks in operation, it is advisable to

pump in anti-frost agents into the appli-

ance.

– If it is not possible to store frost free,

shut down device.

 Drain water:

 Screw off water supply hose and high

pressure hose.

 Screw off supply hose at boiler bottom

and drain heating spiral empty.

 Operate device for max. 1 minute until

the pump and conduits are empty.

 Flush appliance with anti-freeze agent:

Note: Observe handling instructions of the

anti-freeze agent manufacturer.

 Fill anti-freeze agent of the trade into

swimmer container.

 Switch on appliance (without heater) till

the appliance has been completely

rinsed.

A certain corrosion protection is achieved

with this as well.

 DANGER

Risk of injury if the machine is left running

in an unattended state. Remove the spark

plug or disconnect the battery before work-

ing on the appliance.

Risk of burns! Do not touch hot silencers,

cylinders or radiator ribs.

– Fuel tank empty

 Refill.

– Liquid softener tank is empty, due to

technical reasons a remainder stays in

the tank.

 Refill.

– Electrodes in the tank are dirty

 Clean the electrodes.

Follow operating instructions of the engine

manufacturer!

– Fuel tank empty.

 Refill.

– HDS 1000 BE: Spark plug (motor) is

dirty/ defective

 Clean or replace the spark plug.

– Safety thermostat at the high pressure

pump has switched off the appliance af-

ter long period of cycle operation.

 Allow the appliance to cool down; then

restart it. Refer section "Interrupting op-

eration".

Frost protection

Troubleshooting

Fuel indicator lamp glows

Indicator lamp liquid softener glows

Appliance is not running

29EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HDS 1000 BE Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info