Bedienungsanleitung Karcher HDS 12-14-4 ST (Seite 26 von 524) (Alle Sprachen)

726290

Zoom out

Zoom in

Vorherige Seite

1/524

Nächste Seite

- 5

Turning the quantity regulation valve in clock-wise direction

will result in higher working pressure and larger volume.

Turning the quantity regulation valve in an anti-clockwise di-

rection will result in lower working pressure and smaller quan-

tities.

DANGER

Risk of injury! When adjusting the pressure/quantity regulation,

make sure that the screw connection of the spray lance does not

become loose.

Turning the water quantity regulator to the right gives more

water flow and higher working pressure.

Turning the water quantity regulator to the left gives lesser

water flow and lower working pressure.

Open the water supply.

Symbol "Engine on"

Release the trigger gun. To do so, push the safety catch to-

wards the back.

Open the trigger gun and set the appliance switch (A) to "1"

(motor on).

The indicator lamp for operational readiness (F) shows that

the appliance is in stand-by mode and ready to be operated.

DANGER

Scalding danger!

ATTENTION

Hot water operations without fuel will cause damage to the fuel

pump. Ensure adequate fuel supply before starting hot water op-

erations.

If required, the burner can also be turned on subsequently.

Symbol "Burner on"

Turn the appliance switch (A) to "Burner on".

Set the desired water temperature on the thermostat (B).

Maximum temperature is 98 °C.

DANGER

Scalding danger! The operating pressure must not exceed 3,2

MPa (32 bar) when operating with temperatures above 98 °C.

For shifting from hot water to steam operations, first cool down the

machine and switch it off. Then do the change-over as follows:



Replace the high pressure nozzle with the steam nozzle

(accessory).

Set the thermostat to 150 °C.

Set the water flow regulation valve of the high pressure pump

to minimum water flow (turn in the anti-clockwise direction).

Set the water flow regulation valve of the high pressure pump

to maximum water flow (turn in the clockwise direction).

Set the water flow regulator at the trigger gun to minimum wa-

ter flow by turning it towards the left.

– If the trigger gun is closed during operation, the appliance will

switch off.

– The appliance will automatically start again when you open

the gun again within the stand-by period (2 ... 8 minutes).

– If the stand-by period is exceeded, the safety time mecha-

nism switches off the pump and the burner. The indicator

lamp Operations Stand-by (F) goes off.

– To restart the appliance, set the appliance switch to "0" and

then switch on the appliance again. If the appliance is operat-

ed using remote control, the appliance can be restarted by us-

ing the corresponding switch of the remote control device.

– Vehicle tyres are only cleaned using the flat spray nozzle

((25°) from a minimum spraying distance of 30 cm. The round

spray should never be used to clean tyres.

The following nozzles can be selected for all other tasks:

Set working pressure and flow rate

Appliance setting

Adjusting the pressure/quantity regulation of the trigger gun

(option)

Operating with cold water

Operating with hot water

Operating with steam

Order No. Type

4.116-000 HDS 9/14

4.116-001 HDS 12/14

Without pressure/quantity regulation at the trigger gun

With pressure/quantity regulation at the trigger gun (option)

Operations stand-by

Selecting the nozzle

Dirt Nozzle Spray an-

gle

Part no.: Pressure

[MPa]

Recoil [N]

HDS 9/14

strong 00060 0° 5.765-240 14 44

medium 25060 25° 5.765-027

light 40060 40° 5.130-087

HDS 12/14

strong 00080 0° 5.765-243 14 55

medium 25080 25° 5.765-061

light 40080 40° 5.765-221

26 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HDS 12-14-4 ST Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info