Bedienungsanleitung Karcher HDS-E 8-16-4M 36kW (Seite 17 von 252) (Alle Sprachen)

726225

Zoom out

Zoom in

Vorherige Seite

1/252

Nächste Seite

– 3

– The lack of water fuse prevents the heater from be-

ing switched on when there is a water shortage.

– The lack of water fuse switches the pump off after

2 minutes in case of a water shortage to prevent

dry runs.

– The temperature limiter switches off the heater

when the temperature becomes too high.

몇 WARNING

Risk of injury! Appliance, accessories, supply lines and

connections must be in fault-free condition. If they are

not in a perfect state then the appliance must not be

used.

 Lock parking brake.

Figure 3

Figure 4

Note: Push the bottle in securely to penetrate the clo-

sure. Do not remove bottle until it is empty.

Note: To protect the appliance, the heater is switched

off 5 hours after the system care bottle is empty.

– The system care effectively prevents the calcifica-

tion of the pump while operating with calcified tap

water. It is dosed into the supply in the boiler drop

by drop.

– The metering is set to medium water rigidity by the

manufacturer

Note: A system care bottle is included in the delivery.

 Replace the system care bottle.

 Determining the hardness of tap water:

– through the public water supply works,

– using a hardness tester (order no. 6.768-004)

 Set the service switch according to the water hard-

ness in the table.

Note:

– RM 110 prevents system calcification if the water is

hard.

– RM 111 prevents the formation of black water and

cares for the pump in the presence of soft water.

 DANGER

Risk of injury!

– Use Kärcher products only.

– Under no circumstances fill solvents (petrol, ace-

ton, diluting agent etc.)

– Avoid eye and skin contact.

– Observe safety and handling instructions by the de-

tergent manufacturer.

Kärcher offers an individual cleaning and care ap-

pliances program.

Your dealer will consult you gladly.

 Refill detergent.

Note: The EASY!Lock system joins components with a

quick-fasten thread solidly and securely with just one

turn.

Figure 5

 Join the spray lance with the trigger gun and tighten

until hand-tight (EASY!Lock).

 Insert the high pressure nozzle onto the spray

lance.

 Install union nut and hand-tighten it (EASY!Lock).

 Join the high-pressure hose with trigger gun and

high-pressure connection of the appliance and

tighten until hand-tight (EASY!Lock).

For connection values refer to technical specifications.

 Connect the supply hose (minimum length 7.5 m,

minimum diameter 3/4“) to the water connection of

the unit and to the water inlet (e.g. tap) using the

water connection adapter.

Note: The supply hose is not included in the scope of

delivery.

– For connection values, see technical data and type

plate.

– The electrical connections must be done by an

electrician according to IEC 60364-1.

– The voltage indicated on the type plate must corre-

spond to the voltage of the electrical source.

– The installation of the electrical plug may only be

performed by the authorised customer service/

electrician. The electrical plug is not included.

 DANGER

Risk of injury on account of electric shock!

– Unsuitable electrical extension cables can be haz-

ardous. Only use electrical extension cables out-

doors which have been approved and labelled for

this purpose and have an adequate cable cross-

section.

–

Always unwind extension lines completely.

– The plug and coupling of the extension cable used

must be watertight.

Water shortage safeguard

Temperature controller

Start up

Installing the handle

Attach the wheel caps

Replace the system care bottle

Adjusting the dosage of the system care

Advance RM 110/RM 111

Water hardness

(°dH)

Scale on the ser-

vice switch

System care

products to be

used

<3 3 (presetting) RM 111

3...7 1 RM 110

7...14 2 RM 110

14...21 3 (presetting) RM 110

>21 4 RM 110

Refill detergent

Install the hand-spray gun, the jet pipe, the

nozzle and the high pressure hose

Water connection

Power connection

17EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HDS-E 8-16-4M 36kW Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info