Bedienungsanleitung Karcher HWE 860 (Seite 7 von 68) (Alle Sprachen)

726319

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

- 2

1 Indicator lamp (green) - heater on

2 Switch for manual/automatic operation

3 Indicator lamp (red) - fill level of liquid

softener

4 Main switch

5 Control board

1 Temperature limiter

2 Temperature controller

 Open the water supply.

 Set temperature regulator to desired

temperature.

 Turn the main switch to position “1”.

 Set switch to manual or automatic oper-

ation.

We recommend the following cleaning tem-

peratures:

– Light contaminations

30-50 °C

– Contaminations containing protein, i.e.

in the food processing industry

max. 60 °C

– Vehicle cleaning, machine cleaning

60 -85 °C

Note: If the working pressure and the flow

rate are changed, the water temperature

will change as well.

 Turn switch for manual/automatic oper-

ation to position "0".

 Turn the main switch to position “0”.

 Shut off water supply.

 Unscrew the water inlet hose and high

pressure hose from the appliance.

 Unscrew closing stopper on the bottom

of the boiler and empty the boiler.

 Let the high-pressure pump run for

max. of 1 minute, until the pump and

pipes are empty.

The machine should be stored in frost-free

rooms. In case there is frosting risk, for e.g.

if the machine is installed in open areas,

then the machine must first be emptied and

flushed using an anti-freezing agent.

ATTENTION

Risk of damage! Frost will destroy the not

completely water drained device.

 Drain water.

 Flush device with anti-freeze agent.

A certain corrosion protection is

achieved with this as well.

몇 CAUTION

Risk of injury and damage! Observe the

weight of the appliance when you transport

it.

 When transporting in vehicles, secure

the appliance according to the guide-

lines from slipping and tipping over.

몇 CAUTION

Risk of injury and damage! Note the weight

of the appliance in case of storage.

This appliance must only be stored in inte-

rior rooms.

 DANGER

Risk of injury! The main switch is to be

switched off while carrying out any repairs

or maintenance jobs.

 Check the connection cables.

The connection cable must not be dam-

aged (risk of electrical shock). A dam-

aged connection cable must be

replaced immediately by an authorised

Customer Service Engineer or an elec-

trician.

 Check hot water hose.

The hot water hose must not be dam-

aged. A damaged hose must be re-

placed immediately (danger of burns).

Calcified appliances worsen the heat trans-

fer and the efficiency is reduced.

 DANGER

Risk of explosion due to combustible gas-

es! Smoking strictly prohibited during de-

calcification. Ensure proper ventilation.

 DANGER

Risk of burns injury on account of acid!

Wear protective glasses and protective

gloves.

According to statutory requirements, only

tested and approved boiler decrusting

agents may be used.

– RM 100 (Order No. 6.287-008) dis-

solves chalk and simple compounds of

chalk and detergents residues.

 Fill the boiler with 30 liters of water.

 Connect the water hose directly to the

water input and hang in the other free

end into the container.

 Unscrew the nozzle of the steel pipe.

Also insert the connected spray pipe of

the high-pressure cleaner into the con-

tainer. This is how a cycle is created:

Container - pump - boiler.

 Pour 2 l of decalcifying solution into the

container.

 Let high-pressure pump run.

 The solution must not become hotter

than 60 °C. Ensure that there are no

steam bubbles (do not mistake them for

foam).

 If there is no visible gas generation after

15 minutes, pour another 0.5 l of decal-

cifying solution into the container (max.

concentration 7%). With regular decal-

cifying, this will only take approx. 3 min-

utes.

Operation

Operating elements

Turning on the Appliance

Turn off the appliance

Shutting down

Emptying the appliance

Frost protection

Transport

Storage

Care and maintenance

Visual check

Decalcify boiler.

7EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher HWE 860 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info