Bedienungsanleitung Karcher k 2000 (Seite 5 von 21) (Englisch, Französisch, Spanisch)

381830

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

2000 GM English

1. Unit Start-Up

CAUTION:

- FIRE HAZARD! Do not operate the high-pres-

sure cleaner if fuel has been spilled. Instead,

move the machine to a different location and

avoid creating sparks of any kind.

- Do not store, spill or use engine fuels near

open flame or in the vicinity of devices featu-

ring an open pilot flame, such as boilers, water

heaters, etc., or device that may create sparks

of any kind.

- Keep flammable items and materials away

from the engine silencer (minimum distance: 2

meters).

- Do not operate the motor without the silencer,

and check and clean the latter on a regular

basis. Replace if necessary.

- Do not use the motor in woods, scrubs and

grasslands without having a spark catcher at-

tached to the silencer.

- Except during engine tuning, do not operate

the engine with the air cleaner removed, or

without a suitable cover over the air intake.

- Do not make adjustments to governor springs,

governor linkages or other parts that may re-

sult in a higher engine RPM.

- BURN HAZARD! Do not touch hot silencers,

cylinders or cooling fins.

- ASPHYXIATION HAZARD! Exhaust fumes

are poisonous. Never operate the unit in enclo-

sed rooms.

1.1 Unpacking the unit

l Should you notice any transport damage during

unpacking, notify your dealer immediately.

l Because you care about the environment, please

do not dispose of packaging components in regu-

lar domestic waste. Instead, take the items to a

collection point for recycling.

1.2 Attaching the accessories

l Mount the holding basket for the detergent (3 me-

tal hoops) to the push handle.

l Attach the push handle to the unit.

1.3 Engine

l Prior to using the unit, read the operating instruc-

tions supplied by the engine manufacturer, and

pay particular attention to the safety instructions.

l Fill the fuel tank with unleaded petrol. Do not use

a petrol/oil mixture for two-stroke engines.

l The engine is supplied without engine oil. A cer-

tain amount of engine oil is packaged with the

unit. Pour this engine oil into the oil filler hole on

the engine.

l Check the engine oil level. Do not start the engine

if the oil level has dropped below the „MIN“ level.

Top up oil if necessary.

1.4 Pump

l The pump is filled with oil. An oil change is not

required.

1.5 Water inlet

l See „Specifications“ for connection data.

1. Screw male coupling (11) onto the machine.

Do not overtighten.

2. Screw female coupling (10) onto male end of gar-

den hose. Be sure the hose end is in good condi-

tion so a leak does not occur. Do not overtighten.

3.To connect, push female coupling onto male

coupling all the way until it clicks

twice to assure

full flow of water to the pump.

Caution: Failure to push female coupling on all the

way can damage the pump if allowed to run dry.

4. Turn on water supply: If leak occurs, retrace steps

1 to 3, making sure connections are tight and that

couplings are not reversed.

Caution: The male and female connection are

not the same thread size. Reversing the connec-

tions will damage the coupling and cause a water

leak preventing the pump from priming properly.

1.6 Suction feed operation

To draw water from an open reservoir, proceed as

follows:

l Remove the threaded coupling from the unit’s

water inlet, and directly connect a suction feed

hose with filter (order no. 4.440-238) to the water

inlet.

l Set the metering ring on the detergent suction

hose to zero.

l Without the high-pressure hose being attached,

operate the pump until a solid stream of water

exits at the high-pressure outlet.

l At this point, connect the high-pressure hose

again.

Note: Dirt in the feed water could lead to the ap-

pliance being damaged. To avoid this risk, we

recommend fitting a filter. A suitable filter with

3/4" connection (order no. 4.730-059).

1.7 Spray lance

l To attach the spray lance to the hand gun, insert

the spray lance into the bayonet coupling of the

hand gun. Overcoming the spring pressure, firmly

press the lance into the coupling and twist it a

quarter-turn until it locks into place.

If required, you can use the additional spray lance

extension.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher k 2000 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info