Bedienungsanleitung Karcher K 386 MD PLUS (Seite 11 von 160) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

78225

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

English 11

Definition of abbreviations used:

HP = High pressure

DT = Detergent

When unpacking the product, make sure that no

accessories are missing and that none of the

package contents have been damaged. If you

detect any transport damages please contact

your dealer.

Illustrations on Page 2

1 ON/OFF switch for appliance

2 Power cable with plug

3 HP outlet

4HP hose

5 Trigger gun with safety catch

6 Connection for water supply with filter

7 Coupling element for water connection

8 DT tank

9 DT suction hose with filter

10 DT metering regulator

11 Accessory mount, trigger gun

12 Accessory mount, HP hose

13 Accessory mount, spray lance

14 Transport handle

15 Spray lance with pressure regulation (Vario

Power)

When the appliance is delivered, the HP hose

and trigger gun are not attached, this prevents

buckling. Please mount these before using the

appliance for the first time.

Î Push out the safety clip in the trigger gun us-

ing e.g. a small screwdriver.

Î Join HP hose and trigger gun together.

Î Push clip in until it engages and check that it

is securely fastened by pulling on the HP

hose.

Î Remove cable tie and unroll HP hose

For connection values, see type plate/technical

data.

Observe regulations of water supplier.

Î Use a fibre-reinforced hose (not included)

with a standard coupling: - Minimum diame-

ter, 1/2 inches (13 mm). - Minimum length,

7.5 m.

Î Screw the coupling unit (supplied) to the wa-

ter connection on the appliance.

Î Push the water supply hose onto the cou-

pling unit, then connect it to the tap.

ṇ Caution

Never operate the high-pressure cleaner when

the tap is turned off as dry running will damage

the HP pump.

If the water supply is not clean, the Kärcher water

filter must be used (special accessory - order No.

4.730-059).

The appliance is not suited for use in

the drinking water supply network. It is

necessary to install a suitable system

separator from Kärcher, if the device is

to be used in the drinking water supply network.

When fitted with the appropriate accessories,

this high-pressure cleaner can draw in surface

water, e.g. from water butts or ponds (max. suc-

tion height 0.5 m).

Î Use the Kärcher water filter to protect the HP

pump and accessories (special accessories,

order no. 4.730-059). This filter removes dirt

from incoming water.

Î As the standard coupling system is not suita-

ble for use in suction mode, the Kärcher suc-

tion hose with integrated filter should be used

instead (special accessory, order no. 4.440-

238) and suspended inside the water butt.

Î Remove air from appliance before operation:

Switch on the appliance when the HP hose is

not connected and run it until the water which

discharges from the HP outlet is free of bub-

bles. Switch off appliance and connect HP

hose.

Note: Fill suction hose with water before use,

this will help ventilate the pump of air.

Commissioning and operation

Description of the Appliance

Initial start-up

Water supply

Water supply from mains

Drawing in water from open reservoirs

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher K 386 MD PLUS Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info