Bedienungsanleitung Karcher K 4 Full Control (Seite 15 von 166) (Alle Sprachen)

657287

Zoom out

Zoom in

Vorherige Seite

1/166

Nächste Seite

– 9

 DANGER

Risk of electric shock.

 Prior to all work on the appliance, switch off the ap-

pliance and pull the power plug.

Clean the sieve in the water connection regularly.

 Remove coupling from the water connection.

ATTENTION

The sieve must not be damaged.

Illustration

 Pull the sieve out using flat pliers.

 Clean the sieve under running water.

 Reinsert the sieve into the water connection.

The batteries are depleted if nothing is shown on the

display of the trigger gun anymore.

Two batteries or accumulators of the size AAA are re-

quired.

Illustration

 Push the locking slide.

 Open battery compartment.

 Remove the batteries.

 Insert new batteries and observe the correct orien-

tation of the terminals.

 Close battery compartment.

 Dispose of the used batteries according to the local

provisions.

 DANGER

Risk of electric shock. Turn off the appliance and remo-

ve the mains plug prior to performing any care and

maintenance work.

Repair work and work on the electrical components may

only be performed by an authorised customer service.

You can rectify minor faults yourself with the help of the

following overview.

If in doubt, please consult the authorized customer ser-

vice.

 Push the lever of the trigger gun, the device will

switch on.

 Check whether the voltage indicated on the type

plate corresponds to the voltage of the mains sup-

ply.

 Check the mains connection cable for damages.

 Motor overloaded, the motor circuit breaker has

tripped.

– Turn off the appliance "0/OFF".

– Allow the device to cool down for one hour.

– Switch on the device and put it into operation again.

If the malfunction occurs repeatedly, have the de-

vice checked by the customer service.

Voltage reduction due to weak mains supply or when

using an extension cable.

 Upon switch-on, push the lever of the trigger gun

first and then switch the power switch to "I/ON".

 Check setting at the spray lance.

 Check water supply for adequate delivery rate.

 Pull out the sieve in the water connection using flat-

nose pliers and clean under running water.

 Remove air from appliance before operation.

Switch on the appliance without connection the HP

hose (max. 2 minutes) and run it until the water di-

scharging from the HP outlet is free of bubbles.

Switch off appliance and reconnect HP hose.

 Clean high-pressure nozzle: Remove dirt and deb-

ris from the nozzle bore, using a needle and rinse

through with water from the front.

 Check water flow quantity.

 Dropwise leakage of the device is normal for tech-

nical reasons. If the leakage increases contact the

authorized customer service.

 Use Vario Power spray lance.

Turn the spray lance to "Mix" position.

 Check whether the Plug 'n' Clean detergent bottle

is placed into the detergent connection facing

down.

 Check / replace the batteries

Care and maintenance

Clean the sieve in the water connection

Changing the batteries of the trigger gun

Troubleshooting

Appliance is not running

Appliance does not start, motor hums

Pressure does not build up in the appliance

Strong pressure fluctuations

Appliance is leaking

No detergent infeed

No pressure indicator on the trigger gun

15EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher K 4 Full Control Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info