Bedienungsanleitung Karcher K 7 Premium ecologic (Seite 18 von 264) (Alle Sprachen)

576573

Zoom out

Zoom in

Vorherige Seite

1/264

Nächste Seite

– 9

You will need the 2 included screws as well

as a Phillips screwdriver PH 2.

Illustration

 Insert both detergent hoses onto the

hose fittings.

 Install the dosage regulator and con-

nect using 2 screws.

Illustration

 Wind up the high-pressure hose on the

hose drum.

Illustration

 Slide the free end of the coiled high

pressure hose through the recesses on

the dosage regulator.

Illustration

 Attach the transport handle, insert the

bolts into the bores and screw them in.

Illustration

 Press the connecting fitting from the

short high pressure hose into the brass

intake until it locks into place audibly.

Check the secure connection by pulling

on the high pressure hose.

Illustration

 Push the high pressure hose into the

trigger gun until it locks audibly.

Note: Make sure the connection nipple

is aligned correctly.

Check the secure connection by pulling

on the high pressure hose.

ṇ Warning

According to the applicable regula-

tions, the appliance must never be

used on the drinking water supply

without a system separator. Use a

suitable system separator manufactured by

KÄRCHER; or, as an alternative, a system

separator as per EN 12729 Type BA. Water

flowing through a system separator is con-

sidered non-drinkable.

Caution

Always connect the system separator to

the water supply, never directly to the appli-

ance!

Observe regulations of water supplier.

For connection values, see type plate/tech-

nical data.

Caution

Hose couplings made of metal with aquas-

top can damage the pump! Please use

plastic couplings or KÄRCHER brass cou-

plings.

 Use a fibre-reinforced water hose (not

included) with a standard coupling.

(Minimum diameter 1/2 inch (13 mm),

minimum length 7.5 m).

 Illustration

Screw the coupling element to the wa-

ter connection on the appliance.

 Push the water supply hose onto the

coupling unit.

 Connect the water supply hose to the

water supply.

 Completely open the water tap.

Note: Impurities in the water can damage

the high-pressure pump and accessories.

For protection, the use of the KÄRCHER

water filter (optional accessory, order no.

4.730-059) is recommended.

Note: The max. suction height is 0.5 m.

 Fill the suction hose with water.

 Illustration

Screw the suction hose into the water con-

nection of the appliance and insert it into the

water source (e.g. rainwater drum).

Caution

Dry runs lasting longer than two minutes

lead to damages to the high pressure

pump. If the appliance does not build up

pressure within two minutes, switch it off

and proceed as instructed in the Chapter

"Troubleshooting".

 Completely uncoil the mains cable.

 Insert the mains plug into the socket.

 Set the appliance switch to "1/ON".

Install the dosage regulator for

detergent

Install the transport handle

Connect the high pressure hose to the

trigger gun

Water supply

Water supply from mains

Drawing in water from open reservoirs

Start up

18 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher K 7 Premium ecologic Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info