Bedienungsanleitung Karcher K 8.55 HS PLUS (Seite 13 von 220) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

79220

Zoom out

Zoom in

Vorherige Seite

1/220

Nächste Seite

English 13

 Do not operate the appliance at tempera-

tures below 0 °C.

 Observe a distance of at least 30 cm when

using the jet to clean painted surfaces to

avoid damaging paintwork.

 Never leave the appliance unattended

when it is in operation.

 Make sure that the power cable or exten-

sion cables are not damaged by running

over, pinching, dragging or similar. Pro-

tect the power cable from heat, oil, and

sharp edges.

 All current-conducting parts in the working

area must be protected against jet water.

 The appliance may only be connected to

an electrical supply which has been in-

stalled in accordance with IEC 60364.

 The appliance may only be connected to

alternating current. The voltage must cor-

respond with the type plate on the appli-

ance.

 The maximum tolerable mains impedance

at the electrical contact point (see Techni-

cal Data) must not be exceeded.

 For safety reasons, we recommend that

you operate the appliance only via a

earth-leakage circuit breaker (max.

30 mA).

 Cleaning operations which produce oily

waste water, e.g. engine washes, under-

body washes, may only be carried out us-

ing washing stations equipped with an oil

separator.

 This appliance was designed to be used

with detergents which are supplied or rec-

ommended by the manufacturer. The use

of other detergents or chemicals may

compromise the safety of the appliance.

Caution

Safety devices protect the user and must not

be modified or bypassed.

The appliance switch prevents unintentional

operation of the appliance.

This lock locks the lever of the trigger gun and

prevents the inadvertent start of the appli-

ance.

The overflow valve prevents the permissible

working pressure from being exceeded.

If the lever on the trigger gun is released the

pressure switch turns off the pump, the high-

pressure jet ist stopped. If the lever is pulled

the pump is turned on again.

The water shortage safeguard will shut the

burner off as soon as the pump pressure falls

below 25 bar.

If the permitted working temperature is ex-

ceeded, the safety thermostat switches off the

pump.

The high pressure hose is specially construct-

ed with reinforced walls to handle water pres-

sure up to 13 MPa (1900 psi) - it can be easily

damaged and should be stored carefully.

 Do not kink.

 Do not drive vehicles over the hose.

 Do not expose the hose to sharp edges or

corners.

Misuse will lead to ballooning or premature

failure and will invalidate warranty.

Safety Devices

Power switch

Lock trigger gun

Overflow valve with pressure switch

Water shortage safeguard

Safety thermostat

High pressure hose

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher K 8.55 HS PLUS Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info