Bedienungsanleitung Karcher KST 2 Upright EasyFix (Seite 14 von 160) (Alle Sprachen)

803426

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

14 English

Note

The granulate in the decalcification cartridge may

change colour after it comes into contact with water.

This depends on the mineral content in the water. This

discolouration is harmless and does not have a nega-

tive effect on the device, the cleaning work or the func-

tionality of the decalcification cartridge.

Indicator light at end of the run time

The indicator light shows you when the decalcification

cartridge needs to be replaced.

●The indicator light flashes red 1 hour before the run

time expires.

Illustration R

●When the run time of the decalcification cartridge is

exhausted, the indicator light flashes quickly. The

pump switches off automatically (no water steam) to

prevent damage to the device.

Inserting the decalcification cartridge

ATTENTION

Device damage

There is a risk of damage to the device if the used de-

calcification cartridge is re-used.

Work carefully in order to prevent mixing up the cartridg-

es.

Installation information

When steaming for the first time after removing and re-

inserting the decalcification cartridge, the steam jet may

be weak or irregular, and individual drops of water may

be expelled. The device requires a short running-in pe-

riod in which the decalcification cartridge fills with water.

The steam volume that is expelled increases constantly

until the maximum steam volume has been reached af-

ter approx. 50 seconds.

Note

Removing the water reservoir makes it easier to remove

and install the decalcification cartridge.

1. Pull the mains plug out of the socket.

Illustration N

2. Remove the reservoir cover.

3. Remove the decalcification cartridge.

4. Insert the new decalcification cartridge and press it

firmly into place.

Illustration S

5. Press the steam lever and insert the mains plug into

a socket.

6. Keep the steam lever pressed for 7 seconds.

Illustration T

7. After a successful reset, the device flashes green

twice and then switches to heating mode.

8. Press and hold the steam lever for approximately 50

seconds to vent the decalcification cartridge.

Care of accessories

(Accessories - depending on scope of delivery)

Note

The micro fibre cloths are not suitable for dryer.

Note

Observe the instructions on the washing tag when

washing the cloths. Do not use any liquid softeners as

this will affect the ability of the cloths to pick up dirt.

1. Wash the floor cleaning cloths in a washing machine

at a max. temperature of 60 °C.

Troubleshooting guide

Malfunctions often have simple causes that you can

remedy yourself using the following overview. When in

doubt, or in the case of malfunctions not mentioned

here, please contact your authorised Customer Service.

몇WARNING

Risk of electric shock and burns

Trying to eliminate faults while the appliance is connect-

ed to the mains or has not yet cooled down is always

dangerous.

Remove the mains plug.

Allow the appliance to cool down.

No steam / little steam although there is sufficient

water in the reservoir

The decalcification cartridge has not been inserted or

has been inserted incorrectly.

Fit the decalcification cartridge and/or check that the

decalcification cartridge sits tightly in the reservoir

and press in again if necessary.

The decalcification cartridge has been removed when

filling with water and/or a new decalcification cartridge

has been fitted

Always leave the decalcification cartridge in the wa-

ter reservoir during filling.

Press and hold the steam lever constantly.

The full steam output is reached after approximately

50 seconds.

The indicator light flashes red at regular intervals

Run time of the decalcification cartridge ends soon.

Fit a new decalcification cartridge, see chapter In-

serting the decalcification cartridge.

No steam although there is sufficient water in the

reservoir. The indicator light flashes red quickly.

Run time for the decalcification cartridge has expired

Fit a new decalcification cartridge, see chapter In-

serting the decalcification cartridge.

If a new decalcification cartridge has already been

installed and this error still occurs, the reset process

has probably not been carried out correctly. Please

follow the steps below to reset it:

1 Pull the mains plug out of the socket.

2 Press and hold the steam lever constantly.

3 Plug in the mains plug and hold the steam lever for

7 seconds until the indicator lights flash green twice.

See chapter Replacing the decalcification cartridge.

Warranty

The warranty conditions issued by our relevant sales

company apply in all countries. We shall remedy possi-

ble malfunctions on your appliance within the warranty

period free of cost, provided that a material or manufac-

turing defect is the cause. In a warranty case, please

contact your dealer (with the purchase receipt) or the

next authorised customer service site.

(See overleaf for the address)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher KST 2 Upright EasyFix Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info