Bedienungsanleitung Karcher NT 50-1 Tact L (Seite 15 von 176) (Alle Sprachen)

804071

Zoom out

Zoom in

Vorherige Seite

1/176

Nächste Seite

English 15

Removing the dust bag

●The dust bag (special accessories) must always be

removed when vacuuming wet substances.

1. Unlock and remove the suction head.

2. Fold up the dust bag (special accessories).

Illustration G

3. Close the dust bag (special accessory) tightly with a

cable tie underneath the opening.

4. Take out the dust bag (special accessories).

5. Clean the container inside with a moist cloth.

6. Dispose of the dust bag (special accessory) in ac-

cordance with statutory provisions.

7. Fit and lock the suction head.

Draining the waste water

NT 50/1 only:

1. Drain the waste water via the drain hose.

Illustration H

General

●We recommend switching off the "Automatic filter

dedusting" function when vacuuming wet dirt with

the crevice nozzle or the upholstery nozzle (option-

al), or when sucking mainly water out of a container.

●The device switches off automatically when the

maximum fluid level is reached.

●When vacuuming non-conductive liquids (e.g. drill

emulsion, oils and grease) the device does not au-

tomatically switch off when the container is full. The

filling level must be continuously monitored and the

container emptied on a timely basis.

●On completion of wet vacuum cleaning: Clean the

main filter element using the filter cleaning. Clean

the electrodes with a brush. Clean the container with

a moist cloth and dry it off.

Clip connection

The suction hose is equipped with a clip system. All ac-

cessory parts with a nominal width of 35 mm can be

connected.

Illustration I

Operation

Turn switch

Switching on the device

1. Connect the mains plug.

2. Set the turn switch to the desired program.

Adjusting the suction power

Only for devices with a built-in socket:

1. Adjust the suction power (min-max) via the rotary

control.

Working with power tools

Only for devices with a built-in socket:

DANGER

Danger of electric shock

Risk of injury and damage.

The socket is only intended for direct connection of pow-

er tools to the vacuum cleaner. Any other use of the

socket is prohibited.

1. Plug the mains plug of the power tool into the power

socket on the vacuum cleaner. The vacuum cleaner

is in Standby mode.

2. Switch on the device at the turn switch.

Note

The vacuum cleaner is automatically switched on and

off with the power tool.

Note

The vacuum cleaner has a startup delay of up to 0.5

seconds and an after-running time of up to 15 seconds.

Note

See the Technical data for the permissible power rating

of the power tool.

3. Remove the angle piece from the suction hose.

Illustration J

4. Install the tool adapter on the suction hose.

5. Connect the tool adapter to the power tool.

Illustration K

Automatic filter dedusting

The device is equipped with a special filter dedusting

function, which is particularly effective against fine dust.

The main filter element is automatically cleaned every

15 seconds (TACT MAX) or every 60 seconds (TACT

MIN) by a blast of air (pulsing noise).

1. Set the turn switch to the desired program (TACT

MIN-TACT MAX).

2. Power dedusting (for particularly severe contamina-

tion of the main filter element): Set the turn switch to

program 2, seal the suction pipe or bender with your

hand and wait for the automatic filter cleaning to fin-

ish (lasts 15 seconds).

Illustration L

Switching off the device

1. Switch off the device at the turn switch.

2. Pull out the mains plug.

Each time after use

1. Empty the container.

2. Vacuum off the inside and outside of the device and

clean with a moist cloth.

Folding the push handle in/out

NT 50/1 only:

1. Release the push handle lock and adjust the push

handle.

Storing the device

1. Store the suction hose and mains cable as shown in

the illustration.

Illustration M

2. Store the device in a dry room and secure it against

unauthorised use.

Transport

몇CAUTION

Failure to observe the weight

Risk of injury and damage

Be aware of the weight of the device during transporta-

tion.

Device OFF

Device ON

Automatic filter dedusting: OFF

Device ON

Automatic filter dedusting: maximum in-

terval

Device ON

Automatic filter dedusting: minimum in-

terval

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher NT 50-1 Tact L Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info