Bedienungsanleitung Karcher PCL4 (Seite 14 von 156) (Alle Sprachen)

724918

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

14 English

Note

If frost-free storage is not possible:

2. Open the water volume regulation valve completely.

3. Stand the device upright and allow it to drain.

Illustration K

Care and service

Replacing the brushes

DANGER

Danger of electric shock

Injuries due to touching live parts

Switch off the device.

Remove the mains plug.

Note

Always replace both brushes at the same time. The

brushes must be replaced when the gearbox housing

touches the ground while cleaning the surface without

exerting pressure on the device.

ATTENTION

Danger of burns

The gearbox can be very hot after use. Allow the device

to cool down before replacing the brushes.

1. Unscrew and remove the brush fasteners.

2. Pull out the worn brushes.

3. Fit the new brushes.

4. Fit and tighten the brush fasteners.

Illustration L

Pay attention to the assignment when fitting the

brush fasteners (left / right, as seen on the type

plate)!

Cleaning the water filter

Note

If the water flow is inadequate then the water filter in the

device must be cleaned.

1. Unscrew the plug connector at the water connec-

tion.

2. Pull out the water filter.

3. Clean the water filter under running water against

the normal flow direction.

Illustration M

4. Fit the water filter.

5. Screw on the plug connector.

Ensure that the sealing ring in the plug connector has

been inserted correctly.

Cleaning

ATTENTION

Improper cleaning

Damage to the device

Do not clean the device with a hose or high-pressure

water jet.

Do not use aggressive detergents.

Do not knock the brush on the ground.

1. Remove soiling, plant residue and sand/stone from

the brush.

2. If necessary, remove the brushes and clean them

under running water.

3. Clean the device with a moist cloth.

Troubleshooting guide

Malfunctions often have simple causes that you can

remedy yourself using the following overview. When in

doubt, or in the case of malfunctions not mentioned

here, please contact your authorised Customer Service.

Device does not run or switches off during opera-

tion

No voltage supply

Check the voltage supply (plug connections of the

extension cable).

The fault current protection switch has triggered

Check the in-house fault current protection switch.

Consult a qualified electrician if the fault occurs fre-

quently.

The motor overload switch has triggered

Allow the device to cool down (at least 10 minutes).

The motor overload switch resets automatically and

the device is ready for operation again.

The power switch must not be pressed during

the cooling phase to avoid the device starting up

unexpectedly. Always wait for the specified

cooling time before restarting the device. In

case of a repeated shut-down, reduce the pres-

sure on the brushes while cleaning and hold the

device at a flatter angle.

Unsatisfactory cleaning results

Dirty brushes

Clean the air brushes.

Worn brushes

Replace the brushes.

Clogged water filter

Cleaning the water filter

Replace the water filter

Clogged water nozzles

Have the water nozzles replaced by an authorised

Customer Service department.

Warranty

The warranty conditions issued by our relevant sales

company apply in all countries. We shall remedy possi-

ble malfunctions on your appliance within the warranty

period free of cost, provided that a material or manufac-

turing defect is the cause. In a warranty case, please

contact your dealer (with the purchase receipt) or the

next authorised customer service site.

(See overleaf for the address)

Technical data

Subject to technical modifications.

EU Declaration of Conformity

We hereby declare that the machine described below

complies with the relevant basic safety and health re-

quirements in the EU Directives, both in its basic design

and construction as well as in the version placed in cir-

culation by us. This declaration is invalidated by any

changes made to the machine that are not approved by

us.

Product: Floor cleaner

Type: PCL 4

Currently applicable EU Directives

2006/42/EC (+2009/127/EC)

Device performance data

Working voltage of the battery V 220-240

Phase ~ 1

Brush speed 1/min 600-800

Brush diameter mm 100

Dimensions and weights

Weight kg 4,9

Length x width x height mm 1281 x 3

07 x 350

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher PCL4 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info