Bedienungsanleitung Karcher PSW 18-20 Battery (Seite 19 von 248) (Alle Sprachen)

725102

Zoom out

Zoom in

Vorherige Seite

1/248

Nächste Seite

English 19

13 Handle

14 Battery pack trigger

15 Type plate

16 Trigger

17 Trigger lockout button

18 Carrying belt

19 Allen key for adjusting the chain tension

20 Bar scabbard

21 Chain oil

22 *Battery Pack Battery Power 18V

23 *Quick Charger Battery Power 18V

* optional

Rechargeable battery pack

The device can be operated with a 18 V Kärcher Bat-

tery Power battery pack.

Initial startup

Installing shaft

If required, the device can be extended with the includ-

ed extension insert.

1. Connect the lower shaft and the extension insert.

Illustration B

2. Connect the upper shaft and the extension insert.

Inserting the carrying belt

The carrying belt helps to lower the device in a con-

trolled manner after cutting and to catch the weight of

the device during use.

Illustration C

1. Hook the carrying belt hooks into the eyelets on the

handle and shaft. Place the carrying belt over one

shoulder. Make sure that the carrying belt can be re-

leased quickly in the event of danger.

Filling the chain oil tank

1. If necessary, clean the area around the filling hole of

sawdust and dirt.

2. Remove the chain oil tank cap.

Illustration D

3. Fill the chain oil into the tank. Check the filling level

of the chain oil on the sight glass and make sure that

the chain oil tank is filled to the maximum below the

filling hole.

Illustration E

4. Wipe up any spilled chain oil with a cloth.

5. Close the chain oil tank cap.

Checking the chain tension

몇 CAUTION

Sharp chain

Incision injuries

Wear protective gloves when working on the chain.

1. Remove the bar scabbard.

Illustration F

2. Carefully pull on the chain.

Illustration G

The distance between the guide rail and the chain

must be 3-4 mm.

3. If necessary, adjust the chain tension (see Chapter

Adjusting the chain tension).

Installing the battery pack

1. Push the battery pack into the mounting in the de-

vice until it audibly latches into place.

Illustration H

Operation

Basic operation

1. Examine the tree and branches for damage such as

rot.

In the case of damaged or rotten branches, seek the

advice of a professional arborist.

2. Remove the bar scrabber.

3. Hold the device firmly with both hands.

Switch on the device

1. Press the trigger lockout button.

Illustration I

2. Press the trigger.

The device starts up.

3. Release the trigger.

The device stops.

Working techniques

When pruning, proceed as follows:

 Place the bar on the branch to be cut and push the

device forward so that the end stop touches the

branch.

Illustration J

The device stabilizes during pruning and the cuts

are made cleaner.

 Where possible, maintain a distance of approx. 15

cm between the tree trunk and the cut.

 Cut small branches that are thin and light a single

cut with the bottom edge of the guide rail.

 Heavier branches of larger diameter may break or

splinter during pruning. Therefore, cut in several

steps:

a Make a cut in the underside of the branch with the

top edge of the guide rail. This cut should be

about one third of the branch diameter.

Illustration K

b Make a cut in the top of the branch.

c If another cut is necessary, never continue cutting

in an existing cut but rather start a new cut.

The following should be noted when pruning:

 Do not raise the bar higher than 60 ° from the hori-

zontal.

 Do not exert excessive force on the guide rail.

 Do not stand under the branch being sawn off.

 Make sure that the falling branch does not endanger

the user or spectators nor damage any objects.

 Maintain a safety distance of at least twice the

branch length when pruning. If this is not possible,

have the work done by a professional arborist.

Removing the battery pack

Note

During longer work breaks, remove the battery pack

from the device and secure it against unauthorised use.

1. Press the battery pack unlocking button to unlock

the battery pack.

Illustration L

2. Remove the battery pack from the device.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher PSW 18-20 Battery Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info