Bedienungsanleitung Karcher SC 1 (Seite 12 von 130) (Alle Sprachen)

657217

Zoom out

Zoom in

Vorherige Seite

1/130

Nächste Seite

– 7

When cleaning painted or plastic-coated surfaces, as

found on kitchen and living room furniture, doors, par-

quet; wax, furniture polish, plastic surfaces or paint can

come loose or stains can be created. When cleaning

these surfaces, briefly steam a cloth and wipe the sur-

faces with it.

ATTENTION

Never direct the steam jet at glued edges as the edge

band may loosen. Do not use the steam cleaner on un-

sealed wooden or parquet floors.

In case of low outside temperatures, especially in the

winter, warm up the window pane by slightly steaming

the entire glass surface. This will prevent tensions on

the surface which might lead to glass breakage.

Then clean the window surface with the hand nozzle

and attachment. Use a squeegee to remove the water

or wipe the surfaces dry.

ATTENTION

Do not direct steam onto the sealed locations of the win-

dow frame to prevent damage.

The steam nozzle or steam gun can also be used with-

out accessories, for example:

– to remove odours and wrinkles from hanging

clothes by steaming them at a distance of 10 to 20

cm.

– for moist dusting, by briefly steaming the cloth and

wiping the furniture with it.

The closer this nozzle is to the contaminated area, the

higher the cleaning effect, as the temperature and the

steam are highest at the nozzle output. Especially suit-

ed for cleaning difficult access locations, joints, fittings,

drains, sinks, toilets, blinds and heaters. Heavy lime

scale can be drenched in vinegar prior to steam-clean-

ing. Let the vinegar penetrate for about 5 minutes.

The round brush can be installed onto the detail nozzle

as an accessory. Attached brushes can therefore be

used to remove heavy soiling.

ATTENTION

Not suitable for cleaning sensitive surfaces.

Illustration

 Attach the round brush to the detail nozzle.

The power nozzle can be installed onto the detail nozzle

as an accessory.

The power nozzle increases the emission speed of the

steam. Therefore, it is well-suited for cleaning very

tough dirt, blowing out corners, grooves, etc.

Illustration

 Attach the power nozzle to the detail nozzle ac-

cording to the round brush.

Pull the terry cloth cover over the hand nozzle. Especial-

ly well-suited for small washable areas, shower stalls

and mirrors.

Suited for all washable walls and floor coverings, e.g.

stone floors, tiles and PVC floors. Work slowly on very

dirty surfaces to allow the steam to act on the dirt for a

longer period of time.

Note

Detergent residue or care emulsions that are still pre-

sent on the surface to be cleaned can lead to streaks

during steam cleaning. However, these will disappear

with repeated cleaning procedures.

Illustration

 Attach the floor cloth to the floor nozzle.

1 Fold the floor cloth the long way and place the floor

nozzle on top of it.

2 Open holding clamps.

3 Place the cloth ends into the openings.

4 Close the holding clamps.

Rinse the boiler of the steam cleaner after completion of

the work.

 Fill the boiler with water and shake it strongly. This

dissolves lime scaling residing on the boiler bottom.

 Empty water out.

As limescale builds up in the appliance, we recommend

to descale the appliance in the following intervals

(TF=tank fillings):

Note

In case of continuous use of commercially available dis-

tilled water, no descaling of the boiler is necessary.

Note

The hardness of the tap water can be inquired at your

water management office or the municipal utilities.

 Disconnect the mains plug from the socket.

 Allow device to cool down.

 Remove the safety lock from the device.

Illustration

 Completely empty the steam boiler to remove exist-

ing water.

 Use KÄRCHER descaler sticks for descaling.

Please follow the dosing instructions on the pack-

aging when preparing the descaler.

ATTENTION

Use caution when filling and emptying the steam clean-

er. The descaling solution can have an aggressive ef-

fect on delicate surfaces.

 Pour the descaling solution into the boiler and allow

it to react for approximately 8 hours.

Cleaning of Coated or Lacquered Surfaces

Cleaning of Glass

Steam nozzle / Steam gun

Detail nozzle

Round brush

Power nozzle

Hand nozzle

Floor nozzle

Care and maintenance

Rinsing the boiler

Descaling the boiler

Degree of hardness ° dH mmol/l RF

I soft 0- 7 0-1,3 35

II medium 7-14 1,3-2,5 30

III hard 14-21 2,5-3,8 20

IV very hard >21 >3,8 15

12 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 1 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info