Bedienungsanleitung Karcher SC 2 Upright EasyFix (Seite 13 von 160) (Alle Sprachen)

803425

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

English 13

4. Store the device in vertical position on a solid base

or on a wall.

Illustration H

5. Store the device in a dry location that is protected

from frost.

Important application instructions

Cleaning the floor areas

We recommend sweeping the floor or vacuum cleaning

it before using the appliance. In this way the floor will be

cleared of dirt and loose particles before the wet clean-

ing.

Cleaning coated or painted surfaces

ATTENTION

Damaged surfaces

Steam can loosen wax, furniture polish, plastic coatings

or paint and edge band from edges.

Do not direct the steam at glued laminated edges as the

edge band may loosen.

Do not use the device for cleaning unsealed wood or

parquet floors.

Do not use the device for cleaning painted or plastic

coated surfaces such as kitchen or living room furniture,

doors or parquet.

How to use the Accessories

Floor nozzle

The floor nozzle is suitable for cleaning washable floor

coverings, e.g. stone floors, tiles and PVC floors, as well

as sealed wooden floors such as parquet and laminate.

ATTENTION

Damage due to steam effect

Heat and the effects of steam can lead to damage.

Check the heat resistance and steam effect on an in-

conspicuous area using a minimal volume of steam pri-

or to use.

Steam clean sealed wooden floors using the correct,

preset steam level, and do not remain in the same posi-

tion on the floor for too long.

Note

Detergent residues or care emulsions on the surface to

be cleaned can cause streaks during steam cleaning,

but these disappear after repeated use.

몇CAUTION

Beware of burns to your feet

The floor nozzle/floor cleaning cloth heats up during

steaming.

Hot water may drip out when pulling off the floor cloth.

Only operate or remove the floor nozzle/floor cleaning

cloth with suitable footwear.

For fastening the floor cleaning cloth to the floor nozzle,

please refer to chapter Installing the floor cleaning cloth

Microfibre floor cloth

The microfibre floor cloth is suitable for cleaning stone

floors, tiles and PVC floors, and also sealed wooden

floors such as parquet and laminate.

Abrasive floor cloth

The abrasive floor cloth is suitable for cleaning insensi-

tive surfaces such as tiles or stone.

ATTENTION

Damage to floor coverings

The abrasive floor cloth can damage sensitive floor cov-

erings and surfaces.

Do not use the abrasive floor cloth for cleaning wooden

surfaces.

Do not use the abrasive cloth with the carpet glider.

Removing the floor cleaning cloth

1. Place one foot on the bottom corner of the floor

cleaning cloth and lift the floor nozzle up.

Illustration C

Note

Initially, the floor cleaning cloth's hook and loop fastener

strip is very strong and cannot be removed from the

floor nozzle easily. After the floor cleaning cloth has

been used several times and washed, it is easier to re-

move from the floor nozzle and it has reached the opti-

mum adhesion.

Removing the floor nozzle from the basic unit

ATTENTION

Material damage due to an unstable device

Removing the floor nozzle makes the device unstable

and it can tip over and damage the device and floor cov-

ering.

Do not remove the floor nozzle from the basic unit after

installation.

Remove the floor nozzle only when sending the device

for servicing.

1. Pull the mains plug out of the socket.

Illustration N

2. Drain the water reservoir.

Illustration O

3. Hold the device tightly by the handle.

4. Actuate the unlocking button for the floor nozzle.

5. The floor nozzle releases from the device and can

be removed.

Illustration Q

6. Store the device safely in a horizontal position.

Care and service

Draining the water reservoir

ATTENTION

Device damage due to water putrefaction

If the device is not put into operation for more than 2

months, the water in the reservoir may putrefy.

Drain the water reservoir before breaks in operation.

1. Pull the mains plug out of the socket.

Illustration N

2. Remove the reservoir cover.

3. Remove the decalcification cartridge.

4. Drain the water reservoir.

Illustration O

Replacing the decalcification cartridge

ATTENTION

Device damage and shortened service life

If the replacement intervals (indicator light) for the de-

calcification cartridge are not observed, there is a risk of

device damage and the service life of the device may be

shortened.

Observe the replacement intervals (indicator light).

Note

The anti-calcification effect of the decalcification car-

tridge is activated as soon as the reservoir is filled with

water, and the device is put into operation. Lime in the

water is absorbed by the granulate in the decalcification

cartridge. Additional descaling is not required.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 2 Upright EasyFix Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info