Bedienungsanleitung Karcher SC 3 Upright EasyFix (Seite 13 von 188) (Alle Sprachen)

724889

Zoom out

Zoom in

Vorherige Seite

1/188

Nächste Seite

English 13

Do not use condensation from the clothes dryer for fill-

ing.

Do not use collected rain water for filling.

Do not use cleaning agents or other additives (e.g.

scents) for filling.

Note

The decalcification cartridge must be installed in the wa-

ter reservoir when filling the water reservoir.

Filling the water reservoir directly on the device

1. Hold the device.

2. Open the water reservoir cover and fill the water res-

ervoir with max. 0.5 L tap water, directly at the de-

vice.

Illustration G

3. Close the reservoir cover.

Removing the water reservoir for filling

1. Hold the device.

2. Turn the lower cable hook upwards.

3. Pull the water reservoir vertically upwards by the

handle.

4. Open the water reservoir cover and fill the water res-

ervoir with max. 0.5 L tap water.

Illustration H

5. Close the water reservoir cover.

6. Insert the water reservoir and press downwards until

it locks into place.

Switching on the device

ATTENTION

Damage to the device and material damage through

tipping over

The device can fall over and be damaged if inadequate-

ly secured during work breaks or storage. Liquid can al-

so escape and damage the floor covering.

Position the device with the floor nozzle on a solid base

or the handle with the wall anti-slip handle in a vertical

position on a solid wall.

ATTENTION

Device damage due to incorrectly set water hard-

ness

The decalcification cartridge only works properly if the

device is adjusted to the local water hardness. The de-

vice may calcify if the water hardness is set incorrectly.

Adjust the device to the local water hardness before first

operation, see chapter Setting the water hardness.

Note

When steaming for the first time after removing and re-

inserting the decalcification cartridge, the steam jet may

be weak or irregular, and individual drops of water may

be expelled. The device requires a short running-in pe-

riod in which the decalcification cartridge fills with water.

The steam volume that is expelled increases constantly

until the maximum steam volume has been reached af-

ter approx. 30 seconds.

Note

Please note that here it is set to steam stage 3 (tiles/

stone), since the running-in period will otherwise be ex-

tended.

1. Place the device on a firm surface.

Illustration I

2. Insert the mains plug into a socket.

Illustration K

3. Press the On switch.

Illustration L

4. The LED operating indicator flashes red.

Illustration M

5. The LED operating indicator lights up constantly

green after approx. 30 seconds.

Illustration N

The device is ready for use.

Regulating the steam volume

The steam volume setting depends on the surface to be

cleaned.

Press the button with the direction arrows on the

handle repeatedly until the desired steam stage is

selected.

Illustration P

3 different steam stages are available:

Note

The maximum steam stage (Tiles/stone) is always se-

lected when the device is switched on.

Press the steam lever after setting the steam vol-

ume.

Illustration O

Refilling water

Note

The water level can be seen through the transparent

fresh water tank.

When topping up the water, the decalcification cartridge

remains secured in the device.

Open the water reservoir cover and fill the water res-

ervoir with max. 0.5 L tap water, directly at the de-

vice.

Illustration G

Remove the water reservoir, open the water reser-

voir cover and fill the water reservoir with max. 0.5 L

tap water, see chapter Filling water.

Illustration H

Interrupting operation

ATTENTION

Material damage due to condensate/moisture

See the chapter Storing the device to prevent material

damage during longer work breaks.

In order to save energy, we recommend that you switch

off the device for breaks in operation of longer than 20

minutes.

1. Press the OFF switch.

Illustration S

Switching off the device

1. Press the OFF switch.

Illustration S

The device is switched off.

2. Pull the mains plug out of the socket.

Illustration T

ATTENTION

Device damage due to water putrefaction

The water in the reservoir may putrefy if the device is

not put into operation for more than 2 months.

Drain the water reservoir before longer breaks in oper-

ation.

Tiles/stone - maximum steam stage

Carpet - medium steam stage

Wood - minimum steam stage

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 3 Upright EasyFix Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info