Bedienungsanleitung Karcher SC 4 Premium (Seite 14 von 174) (Alle Sprachen)

657211

Zoom out

Zoom in

Vorherige Seite

1/174

Nächste Seite

– 8

The power nozzle can be installed onto the detail nozzle

as an accessory.

The power nozzle increases the emission speed of the

steam. Therefore, it is well-suited for cleaning very

tough dirt, blowing out corners, grooves, etc.

Illustration

 Attach the power nozzle to the detail nozzle ac-

cording to the round brush.

The round brush can be installed onto the detail nozzle

as an accessory. This round brush allows to clean large

rounded surfaces (e.g. sink, shower tray, bathtub, kitch-

en sink).

ATTENTION

Not suitable for cleaning sensitive surfaces.

Illustration

 Attach the round brush to the detail nozzle.

Pull the cloth cover over the hand nozzle. Especially

well-suited for small washable areas, shower stalls and

mirrors.

Illustration

 Install hand nozzle on steam gun.

Suited for all washable walls and floor coverings, e.g.

stone floors, tiles and PVC floors. Work slowly on very

dirty surfaces to allow the steam to act on the dirt for a

longer period of time.

Note

Detergent residue or care emulsions that are still pre-

sent on the surface to be cleaned can lead to streaks

during steam cleaning. However, these will disappear

with repeated cleaning procedures.

Illustration

 Connect the extension tubes with the steam gun.

 Connect the floor nozzle to the extension tubes.

Illustration

 Attach the floor cloth to the floor nozzle.

– Tip extension tube far forward until it is perpendic-

ular, thereby the side flaps of the floor nozzle fold

up down.

– Place the floor nozzle on top of the floor cloth, allow

the side flaps to slide into the two tabs of the floor

cloth.

– Tip the extension tube back again, thereby the side

flaps lock and the cloth firmly at the floor nozzle.

Illustration

 During work breaks, hook the floor nozzle into the

parking holder.

Rinse the steam cleaner boiler at the latest after 10 boil-

er fillings.

 Disconnect the mains plug from the socket.

 Allow the steam cleaner to cool down.

 Empty the water reservoir.

 Remove the accessories from the accessory com-

partments.

Illustration

 Open the maintenance lock. For this, place the

open end of an extension pipe onto the mainte-

nance lock, lock it into the guide and unscrew it.

 Fill the boiler with water and swing it strongly. This

dissolves lime scaling residing on the boiler bottom.

Illustration

 Completely empty the steam boiler to remove exist-

ing water.

As limes cale builds up on the boiler walls, we recom-

mend to de scale the boiler in the following intervals (RF

= reservoir fillings):

Note

The hardness of the tap water can be inquired at your

water management office or the municipal utilities.

 Disconnect the mains plug from the socket.

 Allow the steam cleaner to cool down.

 Empty the water reservoir.

 Remove the accessories from the accessory com-

partments.

Illustration

 Open the maintenance lock. For this, place the

open end of an extension pipe onto the mainte-

nance lock, lock it into the guide and unscrew it.

Illustration

 Completely empty the steam boiler to remove exist-

ing water.

 Use KÄRCHER descaler sticks for descaling.

Please follow the dosing instructions on the pack-

aging when preparing the descaler.

 Pour the descaling solution into the boiler and allow

it to react for approximately 8 hours.

 Completely empty the descaling solution after 8

hours. A small amount of the solution will remain in

the boiler. Therefore, you should rinse the boiler

two to three times with cold water to remove any

residues of the descaler.

Illustration

 Completely empty the steam boiler to remove exist-

ing water.

 Allow the storage compartment for the mains cable

to dry.

 Screw the maintenance lock in using the extension

pipe.

 Fill the water reservoir

 The steam cleaner is ready to use.

Note

The floor cleaning cloth and the cloth cover have been

pre-washed and can be used immediately for working

with the steam cleaner.

 You can wash dirty floorcloths and cloth covers in

the washing machine at 60°C. Do not use a liquid

softener as this would affect the ability of the cloths

to pick up dirt. You may tumble dry the terry cloths.

The microfiber cloths are not suitable for the tum-

ble.

Power nozzle

Round brush (big)

Hand nozzle

Floor nozzle

Parking the floor nozzle

Care and maintenance

Rinsing the steam boiler

Descaling the Steam Boiler

Degree of hardness ° dH mmol/l TF

I soft 0-7 0-1,3 100

II medium 7-14 1,3-2,5 90

III hard 14-21 2,5-3,8 75

IV very hard >21 >3,8 50

Care of the Accessories

14 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 4 Premium Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info