Bedienungsanleitung Karcher SC 5 EasyFix Premium Iron (Seite 13 von 194) (Alle Sprachen)

724908

Zoom out

Zoom in

Vorherige Seite

1/194

Nächste Seite

English 13

44 */***Steam switch (bottom)

45 */***Indicator light (orange) - heating

46 */***Steam switch (top)

47 */***Lock for steam switch

48 */***Temperature controller

49 */***Steam connector

*SC 5 EasyFix Iron

**SC 5 EasyFix Premium

***SC 5 EasyFix Premium Iron

Installation

Installing accessories

1. Open the cover on the device socket.

Illustration B

2. Connect the steam connector to the device socket

so that the steam connector audibly engages.

Illustration B

3. Push the open end of the accessory onto the steam

gun so that the unlocking button on the steam gun

engages.

Illustration H

4. Push the open end of the accessory onto the spot-

light nozzle.

Illustration I

5. Connect the extension tubes with the steam gun.

a Push the first extension tube onto the steam gun

so that the unlocking button on the steam gun en-

gages.

The connection pipe is connected.

b Push the second extension tube onto the

first extension tube.

The connection pipes are connected.

Illustration J

6. Push the accessory and / or the floor nozzle onto the

free end of the extension tube.

Illustration K

The accessory is connected.

Disconnecting accessories

1. Set the child lock to the rear.

The steam lever is locked.

2. Push the cover on the device socket down and dis-

connect the steam connector from the device sock-

et.

3. Push the unlocking button and pull the parts apart.

Illustration P

Operation

Filling water

The water reservoir can be removed at any time for fill-

ing or be filled directly at the device.

ATTENTION

Damage to the device

Unsuitable water can block the nozzles or damage the

water level indicator.

Do not fill in pure distilled water. Use a maximum of 50%

distilled water mixed with tap water.

Do not use condensation from the clothes dryer for fill-

ing.

Do not use collected rain water for filling.

Do not use cleaning agents or other additives (e.g.

scents) for filling.

Remove the water reservoir for filling

1. Pull the water reservoir vertically upwards.

Illustration C

2. Fill the water tank vertically with tap water or a mix-

ture of tap water and no more than 50% distilled wa-

ter up to the "MAX" mark.

3. Insert the water reservoir and press downwards until

it locks into place.

Filling the water reservoir directly on the device

1. Fill tap water or a mixture of tap water and no more

than 50% distilled water from a vessel into the filling

hole of the water reservoir up to the "MAX" mark.

Illustration D

Switch on the device

Note

If there is no or too little water in the steam boiler, the

water pump starts to run and pumps water from the wa-

ter reservoir into the steam boiler. The filling process

can take several minutes.

Note

The device briefly closes the valve every 60 seconds

causing an audible soft click. Closing prevents the valve

from clogging. This does not affect the steam output.

1. Place the device on a firm surface.

2. Insert the mains plug into a socket.

Illustration E

3. Turn the selector switch from the OFF position to the

steam setting selection range.

The green heating indicator light flashes.

Illustration F

4. Wait until the green heating indicator stays on.

Illustration G

5. Press the steam lever.

Illustration H

Steam leaks out.

Regulating the steam volume

The expelled steam volume is regulated using the se-

lector switch for steam volume. The selector switch has

the setting options min. steam stage for light soiling to

max. steam stage for heavy soiling. The VapoHydro

function is for the removal of heavy soiling in areas that

are difficult to access.

1. Set the selector switch for the steam volume to re-

quired steam volume.

2. Press the steam lever.

3. Before starting cleaning, point the steam gun at a

cloth until steam is expelled evenly.

Refilling water

If there is not enough water, the water shortage indicator

lamp flashes red and a signal tone sounds.

Note

The water pump fills the steam boiler at intervals. If the

filling is successful, the red water shortage indicator

lamp goes out.

Note

If there is no or too little water in the steam boiler, the

water pump starts to run and pumps water from the wa-

ter reservoir into the steam boiler. The filling process

can take several minutes.

ATTENTION

Damage to the device

Unsuitable water can block the nozzles or damage the

water level indicator.

Do not fill in pure distilled water. Use a maximum of 50%

distilled water mixed with tap water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 5 EasyFix Premium Iron Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info