Bedienungsanleitung Karcher SC 5 EasyFix Premium Iron (Seite 16 von 194) (Alle Sprachen)

724908

Zoom out

Zoom in

Vorherige Seite

1/194

Nächste Seite

16 English

and speeds up the ironing process. In any case, the

ironing board used should have a steam-permeable,

grid-like ironing base surface.

Note

Do not turn on the steam stage for the VapoHydro func-

tion when the steam pressure iron is plugged in, since

otherwise the ironing laundry will get wet.

Recommended steam stages

1. Ensure that tap water or a mixture of tap water and

no more than 50% distilled water is in the steam boil-

er of the steam cleaner.

2. Insert the steam plug of the iron into the unit plug un-

til it clicks into place.

3. Putting the steam cleaner into operation; see Chap-

ter Switching on the device.

4. Wait until the steam cleaner is ready for use.

Steam ironing

All fabrics can be ironed with steam. Iron sensitive fab-

rics or overprints on the reverse or, as the case may be,

according to manufacturer's instructions.

ATTENTION

Damage to garments

Failure to observe the ironing information in the garment

may result in damage.

Observe the ironing information in the garment.

Note

For sensitive textiles, we recommend using the

KÄRCHER non-stick electric iron plate BE 6006.

Note

The iron plate must be hot to prevent steam from con-

densing on the sole plate and dripping onto the ironing

laundry.

The iron can be held vertically for steaming curtains,

dresses, etc.

1. Set the temperature controller of the iron within the

selected range ( /MAX).

As soon as the orange heating indicator light of the

iron goes out, ironing can be started.

2. Press the “steam” switch (top) or the “steam” switch

(bottom).

 Steaming at intervals: Press the “steam” switch.

Steam flows out as long as the switch is pressed.

 Continuous steaming: Pull the lock for the

“steam” switch backwards until it engages. Steam

flows out continuously. To release, push the lock

forward.

3. Before ironing and after pauses in the ironing pro-

cess, direct the blast of steam onto a cloth until the

steam flows evenly.

Dry ironing

ATTENTION

Damage to the device

Water shortage in the steam boiler leads to damage to

the device

Make sure that there is water in the steam boiler.

ATTENTION

Damage to garments

Failure to observe the ironing information in the garment

may result in damage.

Observe the ironing information in the garment.

1. Set the temperature controller of the iron in accord-

ance with the garment.

2. Wait until the iron’s heating indicator light goes out.

The iron is ready for ironing.

Care and service

Descaling the steam boiler

Note

Since the lime clogs the appliance, we recommend des-

caling the appliance based on the number of times the

water reservoir is filled as specified in the table (TF=tank

fillings).

Note

Your water board or municipal utilities authority can pro-

vide information on hardness of tap water.

ATTENTION

Damaged surfaces

The descaler may corrode sensitive surfaces.

Fill and empty the appliance carefully.

1. Switch off the appliance, see Chapter Switching off

the device.

2. Allow the appliance to cool down.

3. Drain the water reservoir.

4. Remove the accessory/accessories from the acces-

sory holders.

5. Open the cap of the accessory compartment.

6. Remove the accessory from the accessory compart-

ment.

7. Open the maintenance lock. To do this place the

open end of an extension tube on the maintenance

lock, insert this into the guide so it engages and

open it.

Illustration S

8. Drain the water completely out of the steam boiler.

Illustration T

ATTENTION

Appliance damage due to descaler

An unsuitable descaler or incorrect dosing of the descal-

er may damage the appliance.

Only use KÄRCHER descaler.

Use 1 dosing unit of the descaler for 0.5 l water.

9. Apply descaler solution to the descaler according to

the details.

10. Fill the descaler solution into the steam boiler. Do

not seal the steam boiler.

11. Allow the descaler solution to take effect for

approx. 8 hours.

12. Drain descaler solution completely out of the steam

boiler.

13. Repeat the descaling process if necessary.

14. Rinse the steam boiler 2-3 times with cold water in

order to drain all the descaler solution residue.

15. Drain the water completely out of the steam boiler.

16. Dry the mounting for the grid connection cable.

Stage Clothing fabrics

Min. steam stage Garments with few wrin-

kles

Max. steam stage Jeans

Synthetics

Wool, silk

Cotton, linen

Hardness range °dH mmol/l TF

I soft 0-7 0-1.3 100

II Medium 7-14 1.3-2.5 90

III Hard 14-21 2.5-3.8 75

IV Very hard >21 >3.8 50

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 5 EasyFix Premium Iron Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info