Bedienungsanleitung Karcher SC 5.800 CB (Seite 24 von 306) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

477894

Zoom out

Zoom in

Vorherige Seite

1/306

Nächste Seite

– 13

ṇ Caution

Use caution when filling and emptying the

steam cleaner. The descaling solution can

have an aggressive effect on delicate sur-

faces.

 Pour the descaling solution into the boil-

er and allow it to react for approximately

8 hours.

ṇ Warning

Do not screw the maintenance lock onto

the appliance during the decalcifying.

Do not use the steam cleaner as long as

there is decalcifying agent in the boiler.

 Completely empty the descaling solu-

tion after 8 hours. A small amount of the

solution will remain in the boiler. There-

fore, you should rinse the boiler two to

three times with cold water to remove

any residues of the descaler.

 Completely empty the steam boiler to

remove existing water (see fig. ).

 Screw the maintenance lock in using

the extension pipe.

 Fill water reservoir (see page 8).

 The steam cleaner is ready to use.

Note: The floorcloth and the terry cloth cov-

er have been pre-washed and can be used

immediately for working with the steam

cleaner.

 You can wash dirty floorcloths and terry

cloth covers in the washing machine at

60°C. Do not use a liquid softener as

this would affect the ability of the cloths

to pick up dirt. You may tumble dry the

cloths.

Often, failures have simple causes and you

can do the troubleshooting yourself using

the following overview. If you are in doubt

or if the failure is not listed here please con-

tact the authorized customer service.

ƽ Danger

Always disconnect the mains plug and al-

low the steam cleaner to cool down before

performing any maintenance work.

Repair works may only be performed by the

authorized customer service.

 Descale the steam boiler.

No water in the water reservoir.

 Fill the water reservoir up to the "MAX"

marking.

No water in the steam boiler. Overheating

protection of the pump was triggered.

 Turn off the appliance.

 Fill the water reservoir up to the "MAX"

marking.

 Turn on the appliance.

Water reservoir has not been inserted prop-

erly or is calcified.

 Remove the water reservoir and rinse it.

 Insert the water reservoir and press

downwards until it arrests.

Steam switch is secured with the lock /

child-proof lock.

 Move the child protection unit forward.

 Set the thermostat to level •••.

 Rinse or decalcify the boiler of the

steam cleaner.

 Turn the selector switch to the steam

level selection range.

During longer breaks from ironing, the

steam in the steam line can condense.

 Direct the first burst of steam at a sepa-

rate piece of cloth.

 Descale the steam boiler.

Care of the Accessories

Troubleshooting

Long heating-up time

Steam boiler is decalcified

No steam

Display - water shortage blinks red and

signal is emitted.

Display - water shortage lights up red.

Steam lever cannot be pressed

anymore

Steam iron "spits out" water!

Steam level VapoHydro selected

After breaks during ironing, water drops

will come out of the steam pressure iron.

High water output

Steam boiler is decalcified

24 EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SC 5.800 CB Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info