Bedienungsanleitung Karcher SE 6.100 (Seite 15 von 194) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

477968

Zoom out

Zoom in

Vorherige Seite

1/194

Nächste Seite

- 4

ṇ

Health risk, risk of damage!

Check the object to be cleaned prior to using

the appliance in an inconspicuous place for

colour fastness and water resistance.

Do not clean water-sensitive floor coverings

such as wood floors (the moisture could pen-

etrate and damage the floor).

Notes:

Warm water (max. 50°C) will increase the

cleaning effect.

Only use detergent pump while operating.

Avoid dry runs as well as unnecessary pres-

sure buildup (dynamic pressure) as much as

possible.

In case of danger of overheating, the thermal

protection switch shuts off the detergent

pump. After cooling off (approx. 20 min), the

pump will be ready to use again.

Illustration

You can remove the water reservoir to fill it.

Add 100 - 200 ml (volume depends on degree

of contamination) of RM 519 into the fresh wa-

ter reservoir, then add tap water - do not over-

fill (watch MAX marker).

 Use the wash floor nozzle.

 Work without the hard surface insert.

Please only use the carpet cleaner RM 519.

Do not clean laminate or parquet floors!

 Use the wash floor nozzle.

 Slide the attachment for hard surfaces

onto the wash floor nozzle from the side.

 Use the wash hand nozzle.

Illustration

 Insert the mains plug into the socket.

 Press the switch for vacuuming, suction

turbine is running.

Illustration

 Close fully the surrounding air separator

at the handle.

Illustration

 Press the switch for spraying, the deter-

gent pump is ready.

Illustration

 Use the lever on the spray handle to spray

on detergent solution.

Illustration

 For continuous spray, the spray lever can

be locked; for this, activate the spray lever

and pull the locking key toward the rear.

 Run across the surface to be cleaned in

overlapping paths. Pull the nozzle back-

wards (do not push).

 Once the wastewater container is full, the

appliance switches off automatically.

Note: Once the appliance shuts off,

switch off the appliance, because the suc-

tion turbine will otherwise start running

again once you open the appliance.

 Release and remove the appliance head.

 Remove the wastewater container and

empty it.

 Rinse the spray tubes in the appliance as

follows:

Fill the detergent container with about 1

liter of clear water.

Hold the nozzle above the drain, and

switch on the spraying pump until the

clear water has been consumed.

– Always work from the light to the shade

(from the window to the door).

– Always work from the cleaned to the un-

cleaned surface.

– Rugs with jute backing can shrink if too

much water is used and can bleed col-

ours.

– Brush high-fiber rugs in the direction of

the weave after cleaning (using a fiber

brush or a scrubber).

– Water-proofing the fabric using Care Tex

RM 762 after the wet cleaning prevents a

quick resoiling of the textile surface.

Wet cleaning of carpets/hard sur-

faces/upholstery

Fill the fresh water reservoir

Wet cleaning of carpeted floors

Wet cleaning of hard surfaces

Wet cleaning of upholstery

Start working

Empty the wastewater reservoir during

operation

End wet cleaning process

Cleaning tips/mode of operation

15EN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher SE 6.100 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info