Bedienungsanleitung Katadyn PowerSurvivor 40E (Seite 8 von 35) (Englisch)

522382

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

Plan Ahead for Manual Operation

The PowerSurvivor 40E watermaker was never intended to be part of a vessel’s “Abandon

Ship” equipment. Its capability for manual operation is useful when normal ship’s power is

unavailable. If you perform a typical installation, it is unlikely that you would have time to remove

the watermaker when abandoning ship. Katadyn produces other desalinators that are

specifically designed to be part of your survival equipment. Please visit our website for

information on the Survivor 35 and Survivor 06 watermakers, both of which are intended for

inclusion in survival kits.

Before finalizing your installation plans, consider how you would manually operate your

watermaker, should the need arise. You will require a source of seawater input and a place to

drain the reject brine, as well as a product freshwater collection container. Typically, the

watermaker will have to be moved to a location convenient for manual pumping. There are two

common approaches to implementing such an arrangement:

• During your installation, leave adequate service loops in the three hoses to

allow the watermaker to be moved to a nearby location convenient for manual

operation. This arrangement eliminates the need to disconnect any of the

hoses.

• Prepare a separate set of hoses to be used during manual operation

(recommended). This approach allows the watermaker to be moved to any

location for manual operation.

More than likely, the plan you choose will be dictated by the location of the space available. In

any case, consider how you would manually operate your watermaker before finalizing your

installation plans.

Installation Procedures

Although every installation has custom as-

pects, the following general instructions

should be useful to the typical installer. Refer

to Figure A-1 (in the Appendix) for

information on parts identification and system

connections.

1. Install Pump: After reading the

comments on the preceding pages, decide on

a location for the main pump/drive assembly.

It should be mounted with the long axis of the

membrane housing in a horizontal position.

The purpose of this requirement is to avoid

two problems:

• If the pump develops a seawater

leak and is located directly above

the drive assembly, the drive

assembly and/or electric motor

may be damaged (Figure 3, left).

• If the drive assembly develops an oil leak and is located directly above the

pump, oil may find its way into the pumping system and damage the

membrane (Figure 3, right).

We recommend securely thru-bolting the pump/drive assembly to a sturdy bulkhead or platform,

using corrosion-resistant 1/4" fasteners with flat washers (See Figure A-1). Pick a location that

allows ample space for routing the required hoses and electrical wires to the pump and motor.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Katadyn PowerSurvivor 40E Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Katadyn PowerSurvivor 40E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info