Bedienungsanleitung Kathrein MSK 120 (Seite 35 von 64) (Englisch)

631835

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

MEASURING FUNCTION: TP SCAN MODE

SCR (also SCIF or single cable systems)

The 2

softkey is used to select the system type.

Type 1 offers a range of four output or transmission frequencies.

Type 2 offers a range of eight output or transmission frequencies.

There are also further detail differences between the types which are however not relevant to operation

of the system.

The 3

softkey is now used to select the system output frequency to be measured.

The 4

softkey is used to select between two satellite positions the vertical and horizontal Sat polarisation

for each.

The selected individual output carrier (UB = user band) can also be switched off here.

The 5

softkey gives access to the column in which the desired satellite transponder frequency can be

input, and underneath it also the appropriate modulation oscillator.

There are also explanatory tables under “Overview of the most important DiSEqC

commands”.

Pressing the

button now sends the respective DiSEqC

command to the Sat system, and

thereby implements the desired appropriate transponder frequency. To show the user what settings have

been transmitted, the input is highlighted in green.

SCR in User mode (by type, in the 2

column)

The 2

softkey is used to set the user mode (your own SCR frequencies).

The 3

softkey is now used to select the appropriate output frequency of the system, previously set

individually. These user SCR frequencies are required in the measurement mode (TP scan). They are

input here in the column of the 3

softkey and are saved when the satellite meter is switched off.

The 4

softkey is used to select between two satellite positions the vertical and horizontal Sat polarisation

for each.

The selected individual output carrier (UB = user band) can also be switched off here.

The 5

softkey gives access to the column in which the desired satellite transponder frequency can be

input, and underneath it also the appropriate modulation oscillator.

There are also explanatory tables under “Overview of the most important DiSEqC

commands”.

Pressing the

button now sends the respective DiSEqC

command to the Sat system, and

thereby implements the desired appropriate transponder frequency.

“Test SCIF” switches on all the SCR carriers (output frequencies) to the single-cable system.

Pressing “All Off” brieﬂ y interrupts the DC power supply to the single-cable system, thereby resetting

these SCR carriers again.

However many SCR matrices have their own power supply, so to reset the SCR carriers by brieﬂ y

interrupting their power supply it is necessary to withdraw the mains plug and reinsert it.

To show the user what settings have been

transmitted, the input is highlighted in green.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kathrein MSK 120 Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kathrein MSK 120

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info