631743
10
Zoom out
Zoom in
Vorherige Seite
1/50
Nächste Seite
Connecting up and putting into operation
10
Decoder connection
Decoders for reception of analogue Pay-TV programmes can be connected up only
via an analogue secondary receiver (see connection diagram 3 in “Connection
examples“ chapter.)
Set up the connection to the secondary receiver as described above.
Using a Scart cable, connect the decoder to the decoder Scart socket of the
secondary receiver.
Take note of secondary receiver and decoder instructions.
Inserting batteries into remote control handset
Remove the cover on the rear of the remote control handset.
Insert both of the batteries supplied into the remote control handset.
Make certain that the batteries are inserted with the correct polarity! Polarity is
marked at the bottom of the battery compartment.
Replace the cover again.
Exhausted batteries are special waste and should not be disposed of with
household refuse. Instead, hand them in to a collection centre for used batteries!
Checking connections and operation
Switch the satellite receiver on via the mains switch on the front of the unit. The
LED display on the unit shows the programme slot P001.
Switch on your TV set.
Tune in to an audio-visual (AV) programme slot on your TV set.
You can now receive the factory-preset TV and radio programmes. To find out how
to tune in additional TV and radio programmes, refer to sections: “Programming TV
programmes“ and “Programming radio station programmes“.
If the “No Signal“ display is shown for all programme slots, the installation of the
system should be checked out. However, if only certain programme slots are
affected, this may be due to an interruption in the signal on the transmission side.
On-screen display OSD
Note: All figures refere to German programmes and the OSD in German language.
How to select the OSD in English is explained on page 37.
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kathrein UFD 510 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kathrein UFD 510

Kathrein UFD 510 Bedienungsanleitung - Deutsch - 48 seiten

Kathrein UFD 510 Bedienungsanleitung - Französisch - 50 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info