Bedienungsanleitung Kaysun AKAY-CF 52 DR10 (Seite 24 von 36) (Englisch)

771408

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

60 cm (24 in) por

above

30 cm (12 in)

from back wail

30 cm (12 in)

on left

60 cm (24 in)

on right

200 cm (79 in)

in front

Wind

Bafe

Strong wind

Strong

wind

 Page 24 

8. Outdoor Unit Installation

Install the unit by following local codes and regulations,

there may be differ slightly between different regions:

Installation Instructions - Outdoor Unit

Step 1: Select installation location

Before installing the outdoor unit, you must choose an

appropriate location. The following are standards that will

help you choose an appropriate location for the unit..

Proper installation locations meet the following

standards:

5Meets all spatial requirements shown in Installation

Space Requirements above

5Good air circulation and ventilation

5Firm and solid - the location can support the unit

and will not vibrate

5Noise from the unit will not disturb others

5Protected from prolonged periods of direct sunlight

or rain

55 Where snowfall is anticipated, raise the unit

above the base pad to prevent ice buildup and

coil damage. Mount the unit high enough to be

above the average accumulated area snowfall. The

minimum height must be 18 inches.

DO NOT install unit in the following locations:

[Near an obstacle that will block air inlets and outlets

[Near a public street, crowded areas, or where noise

from the unit will disturb others

[Near animals or plants that will be harmed by hot

air discharge

[Near any source of combustible gas

[In a location that is exposed to large amounts of

dust [ In a location exposed to a excessive amounts

of salty

SPECIAL CONSIDERATIONS FOR

EXTREME WEATHER

If the unit is exposed to heavy wind:

Install unit so that air outlet fan is at a 90º angle to the

direction of the wind. If needed, build a barrier in front of

the unit to protect it from extremely heavy winds.

See Figures below.

If the unit is frequently exposed to heavy rain or snow:

Build a shelter above the unit to protect it from the rain or

snow. Be careful not to obstruct air ow around the unit.

If the unit is frequently exposed to salty air (seaside):

Use outdoor unit that is specially designed to resist

corrosion.

Step 2: Install drain join (Heat pump unit only)

Before bolting the outdoor unit in place, you must install

the drain joint at the bottom of the unit. Note that there are

two different types of drain joints depending on the type

of outdoor unit.

If the drain joint comes with a rubber seal (see Fig. A),

do the following:

1. Fit the rubber seal on the end of the drain joint that will

connect to the outdoor unit.

2. Insert the drain joint into the hole in the base pan of

the unit.

3. Rotate the drain joint 90º until it clicks in place facing

the front of the unit.

4. Connect a drain hose extension (not included) to

the drain joint to redirect water from the unit during

heating mode.

If the drain joint doesn't come with a rubber seal (see

Fig. B), do the following:

5. Insert the drain joint into the hole in the base pan of

the unit. The drain joint will click in place.

6. Connect a drain hose extension (not included) to

the drain joint to redirect water from the unit during

heating mode.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kaysun AKAY-CF 52 DR10 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kaysun AKAY-CF 52 DR10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info