Bedienungsanleitung Kaysun AMAZON III W (Seite 5 von 12) (Englisch)

771515

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

owner's manual

OPERATION AND PERFORMANCE

Cooling and heating operation of inverter central A/C

●The indoor unit of this air conditioner can be controlled solely,

and the indoor unit in the same system can not run cooling and

heating at the same time.

●When the Cooling and Heating operation confront with each

other, please determine the problem according to the settings of

main unit Mode dial code S5.

1. When set as the Heating Priority Mode, the indoor unit on

Cooling Mode would stop and there will be Stand by or No

Priority displayed on the control panel. Those indoor units which

are running on Heating Mode will run continuously.

2. When the Cooling Priority Mode has been set, the indoor unit

on Heating Mode would stop and there will be Stand by or No

Priority displayed on the control panel. Those indoor units which

are running on Cooling Mode will run continuously;

3. When the Priority Mode has been set, the first indoor unit will

work in Heating Mode that is Heating Priority, please refer to the

ITEM 1 for the control logic. If the first indoor unit is work in

Cooling Mode, that is the Cooling Priority Mode, please refer to

the ITEM 2 for the control logic;

4. In terms of the settings only respond the Heating Mode, the

indoor unit will run in Heating Mode normally, if unit be run in the

Cooling Mode or air Supply Mode, the indoor unit will display

Mode Conflicting;

5. In terms of the settings only respond the Cooling Mode, the

indoor unit will run in Cooling Mode or air supply mode normally,

if unit be run in the Heating Mode, the indoor unit will display

Mode Conflicting.

Features of heating operation

●Warm air will not be blown out immediately at the beginning of

the heating operation, after 3~5minutes (depends on the indoor

and outdoor temperature), until the indoor heat exchanger

become hot, then blows out warm air.

●During Fan operation, if other indoor Units are running on heating

mode, the fan may stop in order to prevent sending heat wind.

Operation conditions

For good performance, please operate the unit under the

conditions as follow.

Protection Device

This protection device will stop the unit automatically in case

the air conditioner is on forced running mode. When

protection device is activated, running indicator light is

lightened and query light flashes. Protection device may start

under the following circumstances:

cooling operation:

●The air inlet or air outlet of main unit is blocked.

● Strong wind is continuously blowing to the air outlet of the

main unit.

heating operation:

●Too much dust and rubbish adhere to the dust filter in the

indoor unit

Power cut

●If power is cut during operation, stop all the operation

immediately.

●Power on again. The operation indicator on the wire

controller flashes.

●Push the ON/OFF button again if you want to restart the

unit.

Mishandling in operation

In case of mishandling caused by lighting or mobile wireless,

please switch off the manual power off the manual power.

Push ON/OFF again when restarting.

Heating capacity

●The heating process is absorbed heat from outdoor,

while expel heat to indoor by hot pump. Once the

outdoor temperature drop down, heating capacity is

degraded correspondingly.

●It is command to equip with other warming facility, when

outdoor temperature is low.

●It is better to equip with additional purchase indoor

auxiliary heating device in paramos area where is in

particularly low outdoor temperature.(See Indoor Unit

Operation Manual for detail information)

orking

condition

Main unit

ambient

temp.

Main unit

ambient humidity

able.3-1

Cooling Heating

0˚C～40˚C

Below 80%

NOTE

Please switch off the power when protection device starts.

Do not restart until the problems are solved.

TROUBLES AND CAUSES

Indoor

temperature

Main unit water

inlet

temp.

17˚C～32˚C

7˚C～45˚C

15˚C～30˚C

CAUTION

Main unit

water inlet flow

8HP:2.7～8.1m3/h ; 10HP:3～9m3/h;

12HP:3.6～10.8m3/h

NOTE

In case the following malfunctions, please switch off the

power and contact the local dealer. Incorrect ON/OFF

operation

Fuse or leakage protector is frequently broken.

Protective device may start if running the unit outside the

above condition, which will prevent the unit from operation.

To start the outdoor unit as a minimum the installation must

have a demand of 10% of the capacity of the outdoor unit.

Foreign matter or water falls in the unit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kaysun AMAZON III W Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kaysun AMAZON III W

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info