Bedienungsanleitung Kaysun KAY-CF 52 DR8 (Seite 26 von 36) (Englisch)

771400

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Cover

Screw

 Page 26 

If you will install the unit on the ground or on a

concrete mounting platform, do the following:

1. Mark the positions for four expansion bolts based on

dimensions chart.

2. Pre-drill holes for expansion bolts.

3. Place a nut on the end of each expansion bolt.

4. Hammer expansion bolts into the pre-drilled holes.

5. Remove the nuts from expansion bolts, and place

outdoor unit on bolts.

6. Put washer on each expansion bolt, then replace the

nuts.

7. Using a wrench, tighten each nut until snug.

WARNING

WHEN DRILLING INTO CONCRETE, EYE PROTECTION

IS RECOMMENDED AT ALL TIMES.

If you will install the unit on a wall-mounted bracket,

do the following:

CAUTION

Make sure that the wall is made of solid brick, concrete,

or of similarly strong material. The wall must be able to

support at least four times the weight of the unit.

1. Mark the position of bracket holes based on

dimensions chart.

2. Pre-drill the holes for the expansion bolts.

3. Place a washer and nut on the end of each expansion

bolt.

4. Thread expansion bolts through holes in mounting

brackets, put mounting brackets in position, and

hammer expansion bolts into the wall.

5. Check that the mounting brackets are level.

6. Carefully lift unit and place its mounting feet on

brackets.

7. Bolt the unit rmly to the brackets.

8. If allowed, install the unit with rubber gaskets to

reduce vibrations and noise.

Step 4: Connect signal and power cables

The outside unit's terminal block is protected by

an electrical wiring cover on the side of the unit. A

comprehensive wiring diagram is printed on the inside of

the wiring cover.

WARNING

BEFORE PERFORMING ANY ELECTRICAL OR

WIRING WORK, TURN OFF THE MAIN POWER TO

THE SYSTEM.

1. Prepare the cable for connection:

USE THE RIGHT CABLE

• Indoor Power Cable (if applicable): H05VV-F or

H05V2V2-F

• Outdoor Power Cable: H07RN-F

• Signal Cable: H07RN-FF

CHOOSE THE RIGHT CABLE SIZE

The size of the power supply cable, signal cable, fuse,

and switch needed is determined by the maximum current

of the unit. The maximum current is indicated on the

nameplate located on the side panel of the unit. Refer to

this nameplate to choose the right cable, fuse, or switch.

a. Using wire strippers, strip the rubber jacket from

both ends of cable to reveal about 40mm (1.57in) of

the wires inside.

b. Strip the insulation from the ends of the wires.

c. Using a wire crimper, crimp u-lugs on the ends of

the wires.

PAY ATTENTION TO LIVE WIRE

While crimping wires, make sure you clearly distinguish

the Live ("L") Wire from other wires.

WARNING

ALL WIRING WORK MUST BE PERFORMED

STRICTLY IN ACCORDANCE WTH THE WIRING

DIAGRAM LOCATED INSIDE OF WIRE COVER OF

THE OUTDOOR UNIT.

2. Unscrew the electrical wiring cover and remove it.

3. Unscrew the cable clamp below the terminal block

and place it to the side.

4. Connect the wire according to the wiring diagram, and

rmly screw the u-lug of each wire to its corresponding

terminal.

5. After checking to make sure every connection is

secure, loop the wires around to prevent rain water

from owing into the terminal.

6. Using the cable clamp, fasten the cable to the unit.

Screw the cable clampd down tightly.

7. Insulare unused wires with PCV electrical tape.

Arrange them so that they do not touch any electrical

or metal parts.

8. Replace the wire cover on the side of the unit, and

screw it in place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kaysun KAY-CF 52 DR8 Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kaysun KAY-CF 52 DR8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info