Bedienungsanleitung Kaysun KFC-S-2T-250D (Seite 7 von 20) (Englisch)

771453

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

I&O manual

While it is housed in the front cowl in version I, which take in air from

the front.

To remove the filter in version I, proceed as following indicated.

To remove the packaging, follow these instructions:

1 Check for visible damage

2 Open the packaging.

3 Check that the packet containing the manual for use and

maintenance is inside

4 Dispose of the packaging material in accordance with current

legislation, at the appropriate waste reception or recycling site.

PRESERVE THE ENVIRONMENT!

Dispose of the packaging materials in compliance

with the national or local legislation in force in your

country.

Fig.2-7

DANGER!

CAUTION

The air filter must be cleaned by blowing it out with compressed air

or washing it in water. Before refitting the filter, make sure it is clean

and completely dry. If the filter is damaged, it must be replaced with

a genuine corresponding filter.

Do not leave the packaging within reach of children.

Handling instructions

CAUTION

2.3 Warnings and suggestions

Always avoid obstructing the flow of air or using the unit as a surface

to lean on, the use of water or aerosol sprays in proximity to the unit

can cause electric shocks and malfunctions.

INSTALLATION AND MAINTENANCE

3.1 Transport and handling

Packaging and components

CAUTION

DANGER!

DO NOT OPEN OR TAMPER WITH THE PACKAGING

BEFORE INSTALLATION.

The units should only be moved and lifted by specialized

personnel trained in these operations.

Check on arrival that the unit has not been damaged during

transport and that it is complete with all its parts.

DANGER!

Movement of the unit should be performed with care, in order

to avoid damage to the external structure and to the internal

mechanical and electrical components.

Also make sure that there are no obstacles or people along

the route, to avoid the danger of collisions or crushing and to

prevent the lifting or handling device from turning over.

All the operations listed below must be carried out in

accordance with current health and safety regulations, both

about the equipment used and as regards the procedure

followed. Before commencing moving operations, check that

the lifting apparatus has the required capacity for the unit in

question.

The units may be moved or lifted either by hand or by means

of a suitable trolley. If the weight of the unit is more than 30

kg, moving units need to be moved at the same time, it is

advisable to put the machines in a container and lift them by

means of a crane or something similar.

Storage conditions

Units in their packaging may be stacked not more than four

high and must be kept under cover.

Clearances and positioning

IMPORTANT!

CAUTION

Incorrect positioning or installation of the unit may amplify

noise levels and vibrations generated during operation.

The units may be mounted vertically, provided that the

correct clearances for positioning are maintained.

Fig.3-1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kaysun KFC-S-2T-250D Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info