Bedienungsanleitung KEF Reference 206-2 (Seite 6 von 19) (Englisch)

508966

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

1110

Under normal circumstances your loudspeakers

will be commissioned by your retailer or

consultant, who will have been trained in their

installation by KEF.

KEF strongly recommend that you do

not attempt to level your loudspeakers

single-handed.

Recruit the assistance of another adult -

or consult an authorised KEF Reference outlet

for assistance which may be chargeable if the

purchase was not made through them originally.

The spike/locking nut combination supplied is

designed to provide small adjustments, not to

compensate for seriously irregular floors.

A spirit level is provided with certain models to

gauge when the loudspeaker is perfectly level.

A rigidly-sited loudspeaker performs better than

one that can move because it enables the cabinet

to remain fixed while the drive units are allowed

to move as determined by the source signal.

Best results will be obtained if the loudspeakers

are level and stable. Check the general stability

of each loudspeaker by gently rocking it from

side to side, front-to-back and diagonally.

Often, you will find that the loudspeaker is close

to vertical, but rocks because one spike (or two

spikes diagonally) seems too short.

If the general stability is good, but the

loudspeaker is leaning to left, right, backward or

forward, then equal minor adjustments to the

two spikes opposite to the direction of lean

should be made.

Adjusting the Feet and/or Spikes

* Only supplied with

Model 207/2

The listening room is one of the most variable

elements in the hi-fi chain and its effect cannot

be emphasised too strongly, nor can its effects be

reliably predicted. Spacing the loudspeakers

approximately 2m - 3m (6ft. - 10ft.) apart will

allow the stereo images to develop fully.

You should sit at a distance at least equal to and

preferably greater than the distance between

the loudspeakers.

Positioning the loudspeaker in a corner or near

to a side wall is not recommended as the

significant bass boost caused by this position will

affect the sound and cause the stereo image to

deteriorate. However, placement close to the

front wall is catered for in the Uni Balance

feature (see later). It is best to place the

loudspeakers symmetrically within the room,

relative to the walls, ceiling and floor,

where possible.

Be aware also that soft furnishings near to a

loudspeaker will deaden the sound - similarly,

nearby reflective surfaces may brighten up the

sound. Move the loudspeakers until you are

satisfied that the sound is right and that the

stereo image is well defined.

Like all other KEF Uni-Q loudspeakers,

your Reference Series loudspeakers are

designed to be used with little or no ‘toe-in’.

However if required a ‘brighter’, or ‘sharper’

sound may be obtained by pointing the

loudspeakers directly towards the listening

position or adjusting the HF output

(via Uni Balance).

Loudspeaker Placement and Room Acoustics

}

min.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

KEF Reference 206-2 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info