Bedienungsanleitung Kelvinator KBM4300WB (Seite 14 von 16) (Englisch)

478053

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

14 Troubleshooting

If you think something may be wrong with your refrigerator, you can carry out some easy checks before calling

for service. You may locate the problem, sparing yourself from inconvenience and saving time and money.

Problem Solution

When your

appliance is

not operating

• Check that the power cord is plugged into the power outlet properly and that the outlet

is switched ‘ON’.

• Try running another appliance from the power outlet. If no power is coming from the outlet

you may have blown a fuse or tripped a circuit of your household power supply.

• Try adjusting the temperature control to a slightly “colder” position.

• It is normal for the freezer fan NOT to operate during the automatic defrost cycle, or for a short time

after the appliance is switched on.

When there

is refrigerator/

freezer noise

Modern refrigerators/freezers with increased storage capacity use high speed compressors. These can

provide a seemingly high level of sound which is quite normal. Normal operational sounds include:

• Occasional gurgling, similar to water boiling.

• Air ow noise (air circulates because of a small fan).

• A popping noise heard during automatic defrost.

Other strange sounds may mean that you need to check and take action. For example, noises may

mean that:

• The cabinet is not level.

• The oor is uneven or weak.

• Bottles are badly placed and rattling.

• There are vibrations from an object on top of or behind or beside the refrigerator.

• The back of the refrigerator cabinet is touching the wall.

Remember it is quite normal for noise to seem louder just after the refrigerator starts operating.

If there are

odours inside

the appliance

• The interior may need cleaning.

• Some foods produce odours.

• Some containers and wrapping can cause odours.

• Ask yourself if the odour started about the same time you started storing something unusual.

When the motor

seems to run more

than expected

Your new appliance provides you with large capacities in both the refrigerator section and the

separate freezer. It is normal for the motor to operate frequently. However, to keep operation to

a minimum, check the following:

• Are doors kept open too long or too often?

• Are controls set too cold? Refer to page 8 “Temperature control”.

• Have large amounts of warm food just recently been stored? Summer, festive seasons and holidays

usually mean a lot more work for your appliance.

• If the day is hot or the room is very warm, the appliance will need to run more than normal.

• The appliance will run more than normal just after you install it or when it has been turned off for a long time.

If the temperature

in the refrigerator

is too warm

• Check that the appliance has enough clearance at the sides, back and top.

Refer to page 4 “Installing your new refrigerator”.

• Refer to page 8 “Temperature control”.

• You may have kept the door open too long or too frequently.

• Food containers or packaging may be holding a door open.

If the temperature

in the refrigerator

is too cold

• Refer to page 8 “Temperature control”.

• Increase the temperature to avoid high energy consumption.

If heavy frosting

occurs in the

freezer

Make sure you fully close the freezer and fridge doors. If the doors are left partly open a heavy frost will

coat the inside of the freezer. If a frost develops, remove it. Take care to properly close the doors and the

frost will not reoccur.

If water drips

on the oor

The defrost water tray, (located on the compressor at the back of the cabinet), may not be properly

positioned, or the drain tube may not be properly positioned to direct water into this tray. You may need

to pull the refrigerator away from the wall to check the tray and tube.

Freezer Door

opens after closing

fridge door

It is normal for the freezer door to momentarily open and re-close when the food compartment door

is closed. If the freezer door stays open, it indicates that the refrigerator cabinet needs to be tilted

backwards a little further. If you call a service person to solve this problem, you will be charged for the

cost of a service call, as this is not a warranty fault.

If you still require service

If you have a problem, and the problem persists after you have made the checks mentioned above, contact your

nearest Electrolux approved Service Centre or the dealer you bought the refrigerator from. Be ready to quote the

model number, 9-digit PNC and 8-digit serial number, which is stated on the label inside the refrigerator compartment.

Troubleshooting

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kelvinator KBM4300WB Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info