Bedienungsanleitung Kenwood CH250 series (Seite 3 von 128) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

463563

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

to use your food

chopper

The knife blade unit comes in 2

arts, a lower and an upper blade.

●

or coarser chopping use the lower

blade on its own.

●

For finer chopping or pureeing use

both blades together. This will also

give a faster result. To use both

blades fit the upper blade onto the

lower blade and turn anti-clockwise

to locate in place ᕡ. Take care as

the blades are sharp.

Note: After processing food, the

upper blade may disengage from the

lower blade. This is normal as the

blade assembly is designed to be

loose fitting to ease separation after

use.

1 Fit the bowl onto the power unit,

then turn clockwise to lock into

place ᕢ.

2 Fit the blade assembly into the bowl.

●

Always fit the bowl and blade

assembly onto the food chopper

before adding ingredients.

3 Cut the food into suitably sized

pieces and place in the bowl. Larger

pieces of food should be cut into

approximately 1 to 2 cm pieces.

4 Fit the lid and turn clockwise to lock

into place ᕣ.

5 Connect to the power supply and

press down on the speed selector to

select the desired speed ᕤ.

●

Press the speed selector lightly to

obtain speed 1.

●

Press the speed selector firmly to

obtain speed 2.

●

Alternatively the speed selector may

be pressed down for short periods

of time to produce a pulsing action.

This can be used to avoid over

processing food.

6 Operate the food chopper until the

desired result is achieved.

7 Reverse the above procedure to

dismantle the unit.

●

Always unplug the food

hopper before removing the

id.

important

●

If preparing food for babies or young

hildren, always check that the

ingredients are thoroughly blended

before feeding.

●

Do not run the food chopper

continuously for longer than

30 seconds. Leave to cool for

2 minutes in between each

30 second operation.

●

Do not operate the food chopper if

the bowl is empty.

●

Always allow hot food to cool before

processing.

●

Do not exceed the maximum

capacities stated or fill above the

400ml level marked on the bowl.

●

Do not place any part of the

chopper in the microwave.

hints

●

If the chopper labours, remove some

of the mixture and continue

processing in several batches,

otherwise you may strain the motor.

●

Remember that chopping hard foods

such as coffee beans, spices,

chocolate or ice will wear the knife

blades faster.

●

Beware of over processing some

ingredients. Stop and check the

consistency frequently.

●

Various spices such as cloves, dill

and cumin seeds can have an

adverse effect on the plastic of your

food chopper.

●

To ensure even processing, stop and

scrape down any food from the side

of the bowl with the plastic spatula

supplied.

●

The best results are obtained by

chopping small quantities at one

time.

●

Cut larger pieces of food into 1-2cm

pieces. A large load or large pieces

may cause uneven results.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood CH250 series Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info