Bedienungsanleitung Kenwood DMX110BT (Seite 28 von 112) (Englisch, Französisch, Portugiesisch, Spanisch)

672826

Zoom out

Zoom in

Vorherige Seite

1/112

Nächste Seite

About this Unit

For USA

Ñ FCC WARNING

This equipment may generate or use radio

frequency energy. Changes or modiﬁcations to this

equipment may cause harmful interference unless

the modiﬁcations are expressly approved in the

instruction manual. The user could lose the authority to

operate this equipment if an unauthorized change or

modiﬁcation is made.

NOTE

• This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful

interference in a residential installation.

• This equipment may cause harmful interference to

radio communications, if it is not installed and used

in accordance with the instructions. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

oﬀ and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment

and receiver.

– Connect the equipment into an outlet on a

circuit diﬀerent from that to which the receiver is

connected.

– Consult the dealer or an experienced radio/TV

technician for help.

! CAUTION

Use of controls or adjustments or performance of

procedures other than those speciﬁed herein may result

in hazardous radiation exposure.

In compliance with Federal Regulations, following

are reproductions of labels on, or inside the product

relating to laser product safety.

JVC KENWOOD Corporation

2967-3, ISHIKAWA-MACHI,

HACHIOJI-SHI, TOKYO, JAPAN

THIS PRODUCT COMPLIES WITH DHHS RULES

21 CFR SUBCHAPTER J IN EFFECT AT DATE OF

MANUFACTURE.

Location: Bottom plate

This transmitter must not be co-located or operated in

conjunction with any other antenna or transmitter.

For Canada

Ñ IC (Industry Canada) Notice

This device complies with Industry Canada licence-

exempt RSS standard(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) this device must accept any interference, including

interference that may cause undesired operation of

the device.

! CAUTION

This equipment complies with FCC/IC radiation

exposure limits set forth for an uncontrolled

environment and meets the FCC radio frequency

(RF) Exposure Guidelines and RSS-102 of the IC radio

frequency (RF) Exposure rules. This equipment has

very low levels of RF energy that is deemed to comply

without maximum permissive exposure evaluation

(MPE). But it is desirable that it should be installed and

operated keeping the radiator at least 20 cm or more

away from person’s body.

Ñ CALIFORNIA, USA

This product contains a CR Coin Cell Lithium Battery

which contains Perchlorate Material – special handling

may apply.

See www.dtsc.ca.gov/hazardouswaste/perchlorate

B5A-2245-00_KEQ_EnFrEsPt.indb 28 2017/09/07 13:47

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood DMX110BT Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood DMX110BT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info