Bedienungsanleitung Kenwood DNX716WDABS (Seite 3 von 36) (Englisch)

672812

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

English |

Before use

and consult a physician.

• Place the battery out of reach of children. In the unlikely

event that a child swallows the battery, immediately

consult a physician.

Ñ Protecting the monitor

• To protect the monitor from damage, do not operate

the monitor using a ballpoint pen or similar tool with

the sharp tip.

Ñ Lens fogging

When you turn on the car heater in cold weather, dew or

condensation may form on the lens in the disc player of

the unit. Called lens fogging, this condensation on the lens

may not allow discs to play. In such a situation, remove the

disc and wait for the condensation to evaporate. If the unit

still does not operate normally after a while, consult your

KENWOOD dealer.

Ñ Precautions on handling discs

• Do not touch the recording surface of the disc.

• Do not stick tape etc. on the disc, or use a disc with tape

stuck on it.

• Do not use disc type accessories.

• Clean from the center of the disc and move outward.

• When removing discs from this unit, pull them out

horizontally.

• If the disc center hole or outside rim has burrs, use the

disc only after removing the burrs with a ballpoint pen

etc.

• Discs that are not round cannot be used.

• 8-cm (3 inch) discs cannot be used.

• Discs with coloring on the recording surface or discs that

are dirty cannot be used.

• This unit can only play the CDs with

This unit may not correctly play discs which do not have

the mark.

• You cannot play a disc that has not been ﬁnalized. (For

the ﬁnalization process see your writing software, and

your recorder instruction manual.)

Ñ Acquiring GPS signal

The ﬁrst time you turn on this unit, you must wait while

the system acquires satellite signals for the ﬁrst time.

This process could take up to several minutes. Make sure

your vehicle is outdoors in an open area away from tall

buildings and trees for fastest acquisition.

After the system acquires satellites for the ﬁrst time, it will

acquire satellites quickly each time thereafter.

Ñ About the front panel

DNX8

DNX7

When removing the product from the box or installing it,

the front panel may be positioned at the angle shown in

(Fig. 1). This is due to the characteristics of mechanism the

product is equipped with.

When the product is ﬁrst powered on works properly, the

front panel will automatically move into the position (initial

setting angle) shown in (Fig. 2).

(Fig. 1) (Fig. 2)

Ñ Cleaning the Unit

If the front panel of this unit is stained, wipe it with a

dry soft cloth such as a silicon cloth. If the front panel is

stained badly, wipe the stain oﬀ with a cloth moistened

with neutral cleaner, then wipe it again with a clean soft

dry cloth.

! CAUTION

• Applying spray cleaner directly to the unit may aﬀect its

mechanical parts. Wiping the front panel with a hard cloth

or using a volatile liquid such as thinner or alcohol may

scratch the surface or erase screened print.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood DNX716WDABS Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood DNX716WDABS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info