Bedienungsanleitung Kenwood DS400 (Seite 2 von 46) (Alle Sprachen)

630896

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

key

햲

weighing platform

햳

‘unit’ touch pad to select

weighing units

햴

display

햵 ‘on/zero’ touch pad

햶 clip for removing battery cover

햷 battery compartment

battery installation

1 Unclip the battery cover on the

underside of the scale by pushing

the clip inwards and then lifting off.

Remove the plastic film between the

battery and its connector by pulling

on the red tab , this will allow the

unit to function.

Note - During use, if the battery

symbol ‘ ’ appears in the display,

it means that battery power is low

and the batteries should be replaced

(see service).

to weigh

Always place the scale on a dry and

flat surface prior to weighing.

Press the ‘on/zero’ touch pad to

switch on. When the display shows

‘0’, place the item to be weighed

onto the platform. The weight will

appear on the display.

Note:-

The scale will read ‘ ’ if it is

trying to weigh above its capacity.

to select weighing units

After switching on the scale, press

the ‘unit’ touch pad. Each time the

touch pad is pressed the weighing

unit displayed will alternate between

g and lb oz.

to add and weigh

After the weight is displayed, press

the ‘on/zero’ touch pad once and

the display will flash twice and then

return to ‘0’. Add the next ingredient

and the weight of that ingredient will

be displayed. This can be repeated

until all the ingredients are weighed.

hen removing an item from the

cale during add and weigh, a ‘-’ will

appear in the display to represent a

inus reading.

ote:-

he maximum weighing capacity is

8 Kg/17 lb 9 oz. This is the total

weight of all ingredients plus the

weight of the container.

auto switch off:

Automatic switch off will occur if the

scale shows the same weight

reading for 3 minutes.

manual switch off:

To conserve the battery power,

switch off the scale when not in use.

To do this, press and hold the

‘on/zero’ touch pad until the display

disappears.

cleaning

Do not immerse the scale in water.

Wipe over the scale with a damp

cloth, then dry thoroughly. Do not

use abrasive or chemical agents to

clean.

important

The scale is for domestic use only.

Always ensure the weighing platform

is thoroughly clean before placing

items directly on its surface.

When weighing do not place items

on the edge of the weighing

platform, always place them in the

centre.

Do not overload the scale by

exceeding the maximum weighing

capacity of 8Kg/17lb 9oz as this

may damage the weighing sensor.

Do not place hot food or hot

containers such as saucepans onto

the weighing platform.

Never cut food on the weighing

platform as sharp implements such

as knives will damage the surface.

Do not subject the scale to

excessive force.

Do not stand the scale near an oven

or other direct source of heat.

English

햴

햳

햲

햵

햷



햶

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood DS400 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info