Bedienungsanleitung Kenwood KDC-8021 (Seite 45 von 52) (Englisch)

606321

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

— 45 —— 45 —

Troubleshooting Guide

? Non-fading output, Non-fading Low Pass Filter and Non-fading

setting can’t be done.28

✔ The <Non-fading output> (page 11) is OFF.29

☞ Turn it ON.

✔ The <Dual zone system> (page 34) is ON.30

☞ Turn it OFF.

? There’s no Front High Pass Filter and Rear High Pass Filter effect.31

✔ The Non-fading preout is being used.

☞ There’s no effect in Non-fading preout.

? The Mask Key item isn’t displayed in the Menu System.33

✔ The Mask Key function is already activated.

☞ When the Mask Key function is activated it isn’t displayed in the

menu items.

? The Touch Sensor Tone doesn’t sound.34

✔ The preout jack is being used.

☞ The Touch Sensor Tone can’t be output from the preout jack.

? Even though Synchronize Clock is ON, the clock can’t be adjusted.35

✔ The received RDS station isn’t sending time data.

☞ Receive another RDS station.

Tuner source

? Radio reception is poor.39

✔ The car antenna is not extended.

☞ Pull the antenna out all the way.

✔ The antenna control wire is not connected.40

☞ Connect the wire correctly, referring to the section on

<Connecting Wires to Terminals>.

? The desired frequency can’t be entered with the Direct Access

Tuning.41

✔ A station that can’t be received is being entered.

☞ Enter a station that can be received.

✔ You’re trying to enter a frequency with a 0.01 MHz unit.42

☞ What can be designated in the FM band is to 0.1 MHz.

Disc source

? "AUX" is displayed without achieving External disc control mode.50

✔ O-N switch is set to "O" side.

☞ Set the switch to "N" side.

✔ Unsupported disc changer is connected.51

☞ Connect the supported disc changer. (page 3)

? The specified disc does not play, but another one plays instead.52

✔ The specified CD is quite dirty.

☞ Clean the CD.

✔ The CD is upside-down.53

☞ Load the CD with the labeled side up.

✔ The disc is loaded in a different slot from that specified.54

☞ Eject the disc magazine and check the number for the specified

disc.

✔ The disc is severely scratched.55

☞ Try another disc instead.

? The specified track will not play.58

✔ Random play or magazine random play has been selected.

☞ Turn off random play or magazine random play.

? Track repeat, disc repeat, track scan, random play, and magazine

random play start by themselves.59

✔ The setting is not canceled.

☞ The settings for these functions remain on until the setting to off

or the disc ejected, even if the power is turned off or the source

changed.

? The specified track will not play.58-a

✔ Random play has been selected.

☞ Turn off random play.

? Cannot play CD-R or CD-RW.60

✔ Finalization processing is not being conducted for CD-R/CD-RW.

☞ Conduct finalization processing with CD recorder.

✔ A non-compatible CD changer is being used to play the CD-R/CD-

RW.61

☞ Use a CD changer compatible with CD-R/CD-RW to play.

KDC-M907 _U.S 04.2.4 4:17 PM Page 45

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KDC-8021 Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood KDC-8021

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info