Bedienungsanleitung Kenwood KDC-W7037 (Seite 43 von 48) (Englisch)

62437

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Some functions of this unit may be disabled by

some settings made on this unit.

! Cannot switch to Aux source.

▲

• AUX is not turned on. ☞ <Built-in Auxiliary input

Setting> (page 34)

• AUX cannot be used when the KCA-iP200 is

connected.

! • Cannot set up the subwoofer.

• Cannot set up subwoofer phase.

• No output from the subwoofer.

• Cannot set up the low pass filter.

▲

• <Subwoofer Output> (page 9) is not set to On.

• The Dual zone function is enabled. ☞ <Audio

Setup> (page 8)

! • Cannot set up the high pass filter.

• Cannot set up the Fader.

▲

The Dual zone function is enabled. ☞ <Audio

Setup> (page 8)

! Cannot set up the subwoofer phase.

▲

Low pass filter is set to Through. ☞ <Audio Setup>

(page 8)

! • Cannot select the output destination of the

subsource in the Dual zone.

• Cannot adjust the volume of the rear speakers.

▲

The Dual zone function is disabled. ☞ <Audio

Setup> (page 8)

! No Audio control effect on AUX.

▲

The Dual zone function is enabled. ☞ <Audio

Setup> (page 8)

! • Cannot register a security code.

• Cannot set up Display Illumination Control.

▲

<Demonstration mode Setting> (page 35) is not

turned off.

! Cannot set up the Power-off timer.

▲

<Security Code> (page 27) is not set.

! Cannot play audio files.

▲

<CD Read Setting> (page 34) is set to "2".

! • Cannot File select.

• Cannot direct music serch.

▲

The Random play function is enabled.

What might seem to be a malfunction in your unit

may just be the result of slight misoperation or

miswiring. Before calling service, first check the

following table for possible problems.

General

? The Touch Sensor Tone doesn’t sound.

✔ The preout jack is being used.

☞ The Touch Sensor Tone can’t be output from the

preout jack.

Tuner source

? Radio reception is poor.

✔ The car antenna is not extended.

☞ Pull the antenna out all the way.

✔ The antenna control wire is not connected.

☞ Connect the wire correctly, referring to the

section on <Connecting Wires to Terminals>

(page 39).

Disc source

? The specified disc does not play, but another one

plays instead.

✔ The specified CD is quite dirty.

☞ Clean the CD.

✔ The disc is loaded in a different slot from that

specified.

☞ Eject the disc magazine and check the number

for the specified disc.

✔ The disc is severely scratched.

☞ Try another disc instead.

Audio file source

? The sound skips when an Audio file is being

played.

✔ The media is scratched or dirty.

☞ Clean the media, referring to the CD cleaning of

the section on <Handling CDs> (page 6).

✔ The audio file is broken or not supported.

☞ Damaged and unsupported files are skipped.

✔ The recording condition is bad.

☞ Record the media again or use another media.

USB device source

? The USB device is not detected.

✔ The USB connector is disconnected.

☞ Connect the connector of the USB device

properly.

? The USB device does not play its audio files.

✔ The USB connector is disconnected.

☞ Connect the connector of the USB device

properly.

Troubleshooting Guide

English

B64-3629-00_00.Indd 43B64-3629-00_00.Indd 43 07.1.6 6:25:33 PM07.1.6 6:25:33 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KDC-W7037 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood KDC-W7037

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info