Bedienungsanleitung Kenwood KHH322WH (Seite 16 von 327) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

706631

Zoom out

Zoom in

Vorherige Seite

1/327

Nächste Seite

to assemble the food mincer

1 Fit the food mincer scroll

inside the food mincer

body

2 Fit the cutter

– cutting side outermost. Ensure

it is seated properly, otherwise you could damage

your food mincer.

3 Fit a screen

. Put the notch over the locating

tab

4 Loosely fit the ring nut

to assemble the pasta maker

Optional: for easier pasta making, warm the parts in

hot water before assembling. Then dry thoroughly

before assembling.

1 Fit the pasta scroll

inside the food mincer

body

2 Fit a screen

. Put the notch over

the locating tab

3 Loosely fit the ring nut

to fit the attachment to the

machine

1 Raise the mixer head.

2 With the attachment in the position shown, align

the drive tabs on the end of the scroll with the

corresponding slots in the bowl tool socket

3 Push the attachment into the socket and turn anti-

clockwise until it locks into place.

4 Hold the feed tube in place and tighten the ring nut

by hand.

5 Fit the tray

important

Never operate the attachment for longer than 10

minutes as this could damage your mixer.

The attachment will not operate unless

the dual speed outlet cover is fitted.

to use your food mincer

Thaw frozen food thoroughly before

mincing. Cut meat into 2.5cm (1”) wide strips.

1 Switch to maximum speed. Using the pusher

gently push the food through one piece at a time.

Do not push hard – you could damage your

food mincer.

2 Once all the food has been minced, switch off and

unplug.

3 Remove the food mincer. Use the spanner

remove the ring nut if it is too tight.

to use the pasta maker

1 Make your pasta dough. – a too-dry mix could

break your pasta maker.

2 Switch to maximum speed.

3 Place some of the mix onto the hopper. Feed a

small amount of mix into the feed tube at a time.

Allow the scroll to clear before continuing.

If the feed tube becomes clogged use the end

of the spanner handle

to push the mix onto

the scroll. Do not push too hard or use the

mincer pusher – you could damage the

pasta maker. Never let the feed tube fill up.

4 When the pasta is long enough, cut to the desired

length.

5 Remove the pasta maker. Use the spanner

remove the ring nut if it is too tight.

Cook rigatoni within 4 hours. Otherwise it will

become brittle and snap.

to cook your pasta

1 Bring a pan three quarters full of water to the boil.

Add salt to taste.

2 Add your pasta and gently boil for 3- 8 minutes,

stirring occasionally.

compact chopper/grinder

attachment

jar

sealing ring

blade unit

to use your compact chopper/

grinder

Use the compact chopper/grinder for milling herbs,

nuts and coffee beans.



Put the ingredients into the jar



Fit the sealing ring

into the blade unit

l

Leaking will occur if the seal is damaged

or incorrectly fitted.



Turn the blade unit upside down. Lower it into the

jar, blades down.



Screw the blade unit onto the jar until finger tight

. Refer to the graphics on the underside of the

blade unit as follows:

- unlocked position

- locked position

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KHH322WH Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info