— 41 —
Attaching Steering Remote Control
Attach the operation section and the light emitting section of the
Steering Remote Control as shown above.
Be sure to attach them to positions that can ensure proper
operation.
• Clean dirt and oil from the positions where the Steering Remote
Control sections are to be attached.
• If the attached position is cold, warm it before attaching.
• The position should be selected so that the product does not
come in the way of steering operation.
• Do not attach anything on the surface of a steering wheel
incorporating an air bag.
2CAUTION
Mounting Example
Accessory3
Removing the Unit
■
Lower the removal tool
toward the bottom, and pull
out the unit halfway whilst
pressing towards the
inside.
4
Pull the unit all the way out
with your hands, being
careful not to drop it.
5
Be careful to avoid injury from the catch pins on the removal tool.
2CAUTION
Catch facing up
Refer to the section “Removing the hard rubber frame (see p.
40)” and then remove the hard rubber frame.
Remove the Hex-head screw with integral washer (M4×8) on
the back panel.
Insert the two removal tools deeply into the slots on each side,
as shown.
3
2
1
