Bedienungsanleitung Kenwood KRC-394 (Seite 29 von 122) (Englisch, Holländisch, Italienisch, Spanisch)

42693

Zoom out

Zoom in

Vorherige Seite

1/122

Nächste Seite

— 29 —

Tuner source

? Radio reception is poor.39

✔ The car antenna is not extended.

☞ Pull the antenna out all the way.

✔ The antenna control wire is not connected.40

☞ Connect the wire correctly, referring to the section on

<Connecting Wires to Terminals>.

? It isn't the set Traffic information sound volume. 43

✔ The set sound volume is less than the tuner sound volume.

☞ If the tuner sound volume is louder than the set sound volume,the

tuner sound volume is used.

Cassette tape source

? Can’t remove tape.44

✔ The cause is that more than 10 minutes has elapsed since the vehicle

ACC switch was turned OFF.

☞ The tape can only be removed within 10 minutes of the ACC

switch being turned OFF. If more than 10 minutes has elapsed,

turn the ACC switch ON again and press the Eject button.

? The Tape Advance and Music Repeat don’t operate correctly.45

✔ The space between the songs on the tape can’t be recognized

because it’s too short.

☞ Have at least 4 seconds between songs.

✔ The space between songs can’t be recognized because there’s too

much noise between songs.46

☞ Reduce the noise between songs.

? The blank skip doesn’t work.47

✔ Because noise is too loud, the non-recorded part can’t be recognized.

☞ Reduce the noise between songs.

? Blank Skip functions at places that are recorded.48

✔ Because the recording level is low, it’s recognized as not recorded.

☞ Turn Blank Skip OFF.

Disc source

? "AUX" is displayed without achieving External disc control mode.50

✔ O-N switch is set to "O" side.

☞ Set the switch to "N" side.

✔ Unsupported disc changer is connected.51

☞ Connect the supported disc changer. (page 3)

? The specified disc does not play, but another one plays instead.52

✔ The specified CD is quite dirty.

☞ Clean the CD.

✔ The CD is upside-down.53

☞ Load the CD with the labeled side up.

✔ The disc is loaded in a different slot from that specified.54

☞ Eject the disc magazine and check the number for the specified

disc.

✔ The disc is severely scratched.55

☞ Try another disc instead.

? The specified track will not play.58

✔ Random play or magazine random play has been selected.

☞ Turn off random play or magazine random play.

? Track repeat, disc repeat, track scan, random play, and magazine

random play start by themselves.59

✔ The setting is not canceled.

☞ The settings for these functions remain on until the setting to off

or the disc ejected, even if the power is turned off or the source

changed.

? Cannot play CD-R or CD-RW.60

✔ Finalization processing is not being conducted for CD-R/CD-RW.

☞ Conduct finalization processing with CD recorder.

✔ A non-compatible CD changer is being used to play the CD-R/CD-

RW.61

☞ Use a CD changer compatible with CD-R/CD-RW to play.

?Track Search can't be done.66-2

✔ For the albums first or last song.

☞ For each album, Track Search can't be done in the backward

direction for the first song or in the forward direction for the last

song.

KRC-394(E)_U.S r1 02.9.24 11:11 AM Page 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KRC-394 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood KRC-394

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info